Struck by running powered equipment irregular movement, kick back · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at D'Annunzio & Sons Inc., I-95 Turnpike South (Car only) between exit 10 and 9, EDISON, NEW JERSEY 08817
on — Fractures , affecting the Foot (feet), toe(s) unspecified.
Final narrative
An employee was giving a hand signal to an excavator operator. The excavator's bucket jumped horizontally and struck the employee's foot, causing multiple fractures.
An employee was removing debris and plywood from the catch plank on a bridge deck. The employee stepped on a piece of catch plank that was cracked and fell 21 feet to the ground below, resulting in a broken left arm and broken right shin.
An employee was assembling a slide rail system and had an interior panel installed into the soil when the panel dropped 2 feet, causing him to lose balance and fall into the excavation. The employee suffered contusions.
An employee was cutting a board using a circular saw. The saw pinched, kicked back, and cut the employee's left ring and little fingers. The employee suffered an amputation to the little finger.
An employee was cutting wood with a circular saw. The saw kicked back, and its blade cut three fingers on the employee's right hand, resulting in an amputation.
An employee was doing a cutback on a piece of lumber using a chop saw. The saw hit a knot, the piece of lumber buckled, then kicked back and broke the kickback guard. The board was then pulled back into the blade, which lacerated the employee's left index and middle fingers.
An employee was cutting wood with a circular saw. The machine lagged and cut the employee's finger. The employee required surgical amputation of the finger at the hospital.
More severe injuries in this industry (NAICS 237990)
A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.
An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.
Employees were securing the fuel line of an outboard motor in preparation for removing the motor from a small vessel located in the equipment yard. A gasoline-related fire occurred and one employee sustained burns to both hands and forearms.
A marine diver/construction worker was working underwater, using a hydraulic dredge to clear sediment away from the base of a dam. The dredge's suction nozzle began migrating toward him, and then pulled in his right hand and forearm. He sustained compartment syndrome in the hand and forearm.
An employee was standing on a sheet of -inch by 4-foot by 8-foot plywood on top of a rebar mat, supervising his crew. As he was moving to alert the crew to an incoming overhead load, he stepped off the plywood and his left foot slipped through the rebar mat and landed on the rebar mat below. His left ankle was broken and dislocated.
An employee was installing fence posts when they stepped into a recently dug hole that was not visible due to rainfall. The employee's leg was fractured.
An employee assisted in cleaning material from a conveyor pit. After the pit was cleaned, the employee proceeded to replace metal safety plates to ensure other employees did not fall into the pit. While replacing one of the last plates, the employee mis-stepped and fell approximately 5 feet into the pit. The employee was hospitalized with back/side bruising, elbow bruising, bone bruises, and/or fractured ribs.
An employee was walking on the sidewalk. When they stepped off the curb, they fell to the ground, resulting in fractures to their tibia, fibula, and a metatarsal.