Tech Systems, Inc.

The injured employee was spotting for a forklift that was loading 2,000-pound ammunition crates onto a flatbed truck. One of the ammo crates turned on its side, fell off the forklift, and crushed the spotter's foot. The employee was hospitalized.

An employee finished a roofing repair patch at a completed installation and was descending from the roof using a permanent ladder when he slipped and fell 12 feet to the ground. He fractured his right foot and was hospitalized.

The injured employee was assisting in the disassembly phase after a radar array had been lowered and secured. The crew began removing load bearing pins from an overhead crane to free the radome. A load bearing pin was stuck. The injured employee went to remove the pin manually as a second team member applied pressure from the opposite side. The pin unexpectedly released and struck the injured employee s right thumb, resulting in partial amputation of the distal phalanx including an open distal phalanx fracture and nail bed laceration.

An employee was shoveling excess material (spillage) that consisted of dry mix, sand, aggregate and cement. As he was shoveling, some material blew back in his face and around his safety glasses. He got a piece of metal in his left eye that required surgery. The employee was hospitalized.

An employee was feeding boards into an edger. They fed a board in and then adjusted the blade for a second board that was wider. When they fed the second board into the edger, it hit the first board and kicked back, striking the employee in the chest. They sustained injuries including a spine fracture, an injured pancreas, as well as potential injuries to their spleen, liver, and intestine. The employee was hospitalized and required surgery.

An employee was helping an operator to pull a cable off a winch. The operator pulled in the line when it hooked some tree brush. The brush then whipped around and struck the employee's arm, resulting in a broken arm.

A co-worker was adjusting an overhead bracket with an impact wrench when the tool flew out of their hand and struck the injured employee in the face. The injured employee sustained an injury to their left eye.

An employee's hand was caught in a conveyor belt as they worked to clear a jam in a piece of equipment. The employee suffered a dislocation to the right elbow, as well as a broken ulna near the elbow, and was hospitalized.

An employee was changing AC filters while on a ladder. The employee stepped up to the second-to-last rung when they slipped and fell about 5 feet to the ground. The employee sustained fractures to their scapula and ribs, a collapsed lung, and a back injury.

An employee was performing restoration activities outside a 45-gallon condensation tank of a boiler system. As they were performing post-maintenance activities after repairing one of the two discharge pumps, one of the discharge valves would not open. The employee closed the intake pump to cool off the system and open the discharge valve. Two employees opened the inlet valve to return the tank to service. After they cracked open the inlet valve, a side wall of the tank blew out, causing the injured employee to suffer steam burns to half their body.

On August 19, 2025, an employee became ill and dehydrated after working outdoors for eight hours, participating in training activities. He was hospitalized.

An employee was ascending a fixed ladder and struck his head on an overhead object that was approximately 20 feet above ground level. The employee sustained neck injuries and tingling in his fingers. The employee was hospitalized.

An employee was drilling a hole into the sealed hold of a vessel so a marine chemist could test its atmosphere. Upon drilling the hole, a gas that was under pressure was released and caught fire at the drill motor, where the employee was holding it. The employee was burned.

An employee was performing restoration activities outside a 45-gallon condensation tank of a boiler system. As they were performing post-maintenance activities after repairing one of the two discharge pumps, one of the discharge valves would not open. The employee closed the intake pump to cool off the system and open the discharge valve. Two employees opened the inlet valve to return the tank to service. After they cracked open the inlet valve, a side wall of the tank blew out, causing the injured employee to suffer steam burns to half their body.

An employee was testing and troubleshooting the gang cylinder valve located in the gang area of the sawmill. The employee's fingertip was amputated by the gang cylinder valve.

An employee was unlocking containers on deck. The employee was de-lashing while standing on the edge of the lid. The lashing bar he was holding came off the cone, causing him to turn 90 degrees and strike a railing behind him. The employee sustained four fractured ribs.

An employee parked a side-by-side on the fixed internal ramp aboard a cargo ship. They exited the side-by-side and went to inspect the cargo below. The side-by-side rolled toward the employee and struck them as they were walking toward the edge of the ramp. The employee was knocked off the ramp and landed on the lower deck approximately 8 feet below. The employee was hospitalized with a fractured shoulder.