COLD SPRING HARBOR, NEW YORK—
JC Steel Erectors Corp.
Struck by suspended or swinging objects n.e.c. · Amputations involving bone loss
At a glance
Federal OSHA recorded a severe workplace injury at JC Steel Erectors Corp., 1 Bungtown Road, COLD SPRING HARBOR, NEW YORK 11724 on — Amputations involving bone loss, affecting the Thumb(s).
Final narrative
An employee was assisting with unloading structural steel that a crane was picking up from a delivery truck and placing onto the ground. The employee's right hand was on a column base plate and a steel beam was next to it. The load shifted and severed his right thumb between the first and second knuckles. The employee sustained the amputation of his right thumb.
Similar incidents · Same event type
POCONO SUMMIT, PENNSYLVANIA—
Ardent Mills
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
NEBRASKA CITY, NEBRASKA—
Concrete Industries Nebraska City
An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.
AUGUSTA, MAINE—
Cives Steel Company New England
An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.
NORTHPORT, ALABAMA—
Hanna Steel Corporation
An employee was placing a board on top of a bundle of steel tubing. A crane was moving a bundle of steel that struck the employee and caught them against another bundle of steel tubing. The employee sustained a crushing injury and hematoma to the right upper leg.
GRAND BAY, ALABAMA—
Tri-State Tree Service LLC
Employees were using a crane to lower large tree stems and branches while removing limbs and branches from the load. This caused the load to shift and strike an employee in the back, resulting in a hematoma on the lower left part of their back and a fractured ankle.
More severe injuries in this industry (NAICS 238120)
COLUMBUS, OHIO—
Foundation Steel, LLC
An employee fell from a step ladder while reaching for a tie-off point. He impacted the ground, and landed on his bolt bag which contained tools. The employee was hospitalized with fractured ribs, and a lacerated spleen and kidney.
ATHENS, TEXAS—
Red Dot Corporation
An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.
JAMAICA, NEW YORK—
Cornell & Company, Inc.
An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.
AUSTIN, TEXAS—
K Constructor, LLC
An employee was unloading a rebar delivery from a flatbed, 19-wheel trailer. The employee rigged the load with wire rope chokers. The load was picked up 3-4 feet above the trailer deck by a crane. The load began to swing and the employee grabbed onto it to prevent it from being pushed off the trailer deck. The crane continued to lift the load, and the employee let go so the crane did not lift him to the third story. The employee fell approximately 12 feet to the ground below, resulting in a back injury and fractured vertebrae.
KINGS MOUNTAIN, NORTH CAROLINA—
Bowman Steel, LLC
An employee was attaching a steel angle plate weighing (approximately 200 pounds) to the end of a structural member (5,000 pounds) and was supported by dunnage. The dunnage was a crane mat (11 inches tall) with a 4x6 board on top of it and it supported five identical members. The main piece was 30.75 feet long, 37.25 feet tall, and 1 food wide. As the employee slid the piece of metal on top of the member to begin attaching it, the entire member began to tip over. The employee went to stop the main piece from tipping over and it landed on his ankle, fracturing it.
More severe injuries in NEW YORK
EAST HAMPTON, NEW YORK—
Garden Angels New York LLC
An employee was cleaning leaves with a backpack blower when he fell from a ladder, resulting in injuries to his head, neck, and back.
SYRACUSE, NEW YORK—
Cashless Tolling Constructors
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
BROOKLYN, NEW YORK—
NYU Langone Hospital-Brooklyn
An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.
CHEEKTOWAGA, NEW YORK—
Caraustar Industrial and Consumer Products Group Inc
An employee's right middle finger was caught in a nip point. The employee suffered an amputation to the middle finger at the first knuckle.
CORNING, NEW YORK—
VILLAGER CONSTRUCTION, INC.
An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.