Federal OSHA recorded a severe workplace injury
at Coreslab Structures (Texas) Inc., 15916 Anderson Mill Rd., CEDAR PARK, TEXAS 78613
on — Amputations, avulsions, enucleations unspecified, affecting the Thumb(s).
Final narrative
A crew was working to untangle a spool of 1/2-inch wire cable. One employee's left thumb became entangled in the cable, causing an amputation/avulsion. The employee was hospitalized.
An employee was setting a stress jack into place, getting ready to stress the cable. His hand was around the ram and his thumb was in the cylinder channel against the back wall. The stressing operator started moving the ram cylinder into position and the cylinder crushed the tip of the employee's left thumb against the back wall.
An employee was securing a load of precast concrete on a trailer. He fell and was knocked unconscious, suffering a concussion, a laceration to the left side of the head, and a skull fracture.
A dunnage board for setting concrete moved, and an employee's left hand was caught between the board and a concrete panel. The employee's middle and ring fingertips were amputated.
An employee was in the process of cleaning and setting a 20' steel siderail for a mold while standing on top of the 2.5' high mold. The employee stuck a piece of rebar into a hole of the mold to adjust the siderail's position in the mold. The employee pulled on the rebar and it came out of the hole, causing the employee to fall to the ground and fracture the right femur.
A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.
An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.
An employee had been cleaning the work area. While lifting a saw, the employee's index finger was lacerated by the saw blade. A tendon was cut and required surgery.
An employee was installing a hydraulic extension cylinder in a tow truck when their leg was caught between the cylinder and the truck frame. The employee was hospitalized with a broken tibia, which required surgery.
An employee was sorting sucker rods. His right hand was caught in the area where the rod hits up against the frame and his index fingertip was amputated just below the nail.
More severe injuries in this industry (NAICS 236210)
An employee was fixing a broken purlin at a worksite when they fell from the framing to the concrete floor approximately 19 feet below. The employee sustained brain bleeding and fractures to their face, vertebrae, and wrists.
Employees were removing scaffolding that was used to repair an ion exchange tank. The line was undergoing the regen process when a piece of scaffold struck a PVC pipe that transported hydrochloric acid (HCl). The injured employee was placing material inside a scaffold rack when he was sprayed in the face with HCl and sustained chemical burns to his eyes, face, chest, right arm, and left leg.
An employee was moving a ramming machine to a staging area. While using the controls on the side of the machine, there was a sudden heavy rainfall causing the equipment to slide. The ramming machine tipped over and caught the employee against the ground. The employee sustained a fracture to the right side of their pelvis and was hospitalized.
The injured employee was training a new employee on a dough machine. She went to show where the batter comes from and her right index fingertip was cut. The employee sustained an amputation to the fingertip. The machine was not guarded at the time of the incident.
An employee was operating a roller machine on a dirt slope when the machine hit a bump and fell onto it's side. While trying to get free of the falling machine, the employee's legs were pinned by the top bar of the cage. The employee was hospitalized and his left leg was amputated. He also sustained fractures to a hand and finger.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.