Caught, entangled in running powered equipment normal operation · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Elmira Stamping & Manufacturing Co., 1704 Cedar Street, ELMIRA, NEW YORK 14904
on — Fractures , affecting the Hand(s), finger(s) unspecified.
Final narrative
An employee was operating a stamp press when their hand was crushed in the machine. The employee was hospitalized with fractured bones and required surgery.
An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.
An employee was working on a production line. The employee went to retrieve parts that came out of the parts holder, and their left hand became caught between a chain and a sprocket. Three fingers on the hand were amputated.
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was operating a pad printer. The employee's finger was caught in the printer and they suffered a fingertip amputation. The part of the printer that caught the employee's finger was unguarded at the time.
More severe injuries in this industry (NAICS 332119)
A forklift operator was switching out a propane tank on his forklift when the tank leaked and sprayed his right hand, resulting in hospitalization due to liquid propane burns. PPE (gloves) were not worn at the time of the incident.
On September 2, 2025, at approximately 10:15 AM, an employee was setting a rest die in a press when the die slipped off the parallels. One of the employee's fingertips became caught in the die, resulting in a fingertip amputation.
On August 19, 2025, an employee was changing tooling on a sizing machine. The employee's left ring fingertip was pinched between the tooling and the machine and was partially amputated.
An employee was loading pipe into a flare machine when a part clamp caught her right hand. The hand was lacerated and broken. A light curtain was in place at the time of the incident.
A maintenance employee was working on the roof of a small office inside the facility. The employee fell through the ceiling and landed on the floor inside the office. The employee sustained fractured ribs and a punctured lung and was hospitalized.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.
An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.