Contact with hot objects or substances · Thermal burns second degree
At a glance
Federal OSHA recorded a severe workplace injury
at Goodyear Auto Service Center, 5601 Bosque Avenue, WACO, TEXAS 76710
on — Thermal burns second degree, affecting the Hand(s) and arm(s) n.e.c..
Final narrative
An employee was performing a dip test on a vehicle's radiator fluid. He waited 30 minutes for the vehicle to cool and then performed a quarter-turn of the radiator cap. The cap flew off and radiator fluid sprayed on his left hand and forearm, resulting in second-degree burns.
Hospitalized Hand(s) and arm(s) n.e.c. Antifreeze
More severe injuries at Goodyear Auto Service Center
An employee was disconnecting hoses after completing a radiator flush. Pressure had built up in the hose and hot radiator fluid was released onto the employee's arms, torso, legs and face.
An employee pulled out a bucket of hot oil from under the fryer. The employee then stood on the table to clean the back wall. He stepped down into the bucket of hot oil, resulting in third-degree burns to his left leg.
An employee was performing maintenance under a kettle. When he removed a tri-clamp on a transfer line, the hot fat and broth material in the kettle poured out onto his arm. The employee was hospitalized with burns.
After completing a run with an oil distributor truck, an employee was working to return (suction) the hot oil to the tank of the truck. When the employee opened one of the valves, hot oil (approximately 385 degrees) sprayed their face, resulting in first-, second-, and third-degree burns.
An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.
An employee was using a water hose to clean debris out of the outfeed of a log conditioning vat. Water began entering the vat from the adjoining vat through a void in the separation wall at the infeed of the vats. As the employee was exiting the vat he had been working in using the access opening at the outfeed, hot water exiting the access opening entered the top of his protective hip wader. It pooled at the bottom of the wader and burned his left foot and ankle.
More severe injuries in this industry (NAICS 423990)
An employee was working to unjam an auger screw. The screw caught his glove, resulting in a severe open fracture to his left lower forearm. He was hospitalized, requiring surgery.
An employee was working in a warehouse without air conditioning on a day when the temperature outside was in the 90s. The employee developed heat stress, became ill, and was hospitalized.
An employee was walking in the middle of the track during heavy rain when he slipped on a rail transition and fell, hitting his arm on the rail. The employee was hospitalized with a fractured left arm.
An employee was scraping down the sides of a mixing machine. The machine activated and her right arm was caught in the auger, resulting in a fractured lower arm.
Two employees were conducting a roll change on a rolling mill machine using a porter bar and a counterweight sleeve. The sleeve slid back and crushed the injured employee's right index fingertip between the sleeve and the counterweight, resulting in a partial amputation.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.