VERNON, ALABAMA—
Trane US, Inc.
Other fall to lower level 6 to 30 feet · Fractures
At a glance
Federal OSHA recorded a severe workplace injury at Trane US, Inc., 8990 AL-18 West, VERNON, ALABAMA 35592 on — Fractures , affecting the Multiple body parts n.e.c..
Watch Trane US, Inc. — free
Get an email when a new federal OSHA severe-injury report for Trane US, Inc. is published. One employer, no account, unsubscribe in one click.
Final narrative
An employee was moving from an extension ladder to a mezzanine to inspect duct work. The employee fell from the ladder to the hardwood floor 10 to 12 feet below, suffering a broken neck vertebra, a broken left humerus, a broken right wrist, and multiple broken ribs.
More severe injuries at Trane US, Inc.
TYLER, TEXAS—
Trane US, Inc.
An employee was troubleshooting a corner post part stacker to determine if there were any faulty sensors. The machine cycled and pushed a slide mechanism into the employee's hand, amputating the tip of the ring finger at the first joint.
GREENVILLE, TEXAS—
Trane US, Inc.
An employee was changing a fan motor on an air conditioning unit. The employee fell from the top of the AC unit to the rooftop about 8 feet below, suffering broken ribs and a broken right collarbone.
ATTLEBORO, MASSACHUSETTS—
Trane US, Inc.
Two employees were removing the condenser head of a chiller. While the head was suspended, it pivoted, causing one employee's finger to be caught between a bolt and a hole. The finger was amputated.
View Trane US, Inc.'s full OSHA safety record →
Similar incidents · Same event type
SYRACUSE, NEW YORK—
Cashless Tolling Constructors
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
JAMAICA, NEW YORK—
Cornell & Company, Inc.
An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.
CRESTVIEW, FLORIDA—
Anderson Columbia Co., Inc.
An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.
ATLANTA, GEORGIA—
Freeman Expositions, LLC
An employee was working on a platform, raised 6 to 8 feet in the air, to get something off a rack. The employee fell from the platform to the ground and sustained a head injury and injury to multiple body parts.
CANAL WINCHESTER, OHIO—
Faler Feed Store, Inc.
An employee was preparing to unjam an auger shaft while standing on a forklift-elevated, job-made platform. The employee's wrench slipped off the equipment, causing them to lose their balance and fall. The employee landed on the ground 14 feet below and suffered fractures to the orbital bone, left elbow, and lower back.
More severe injuries in this industry (NAICS 811310)
BLYTHEVILLE, ARKANSAS—
NATIONAL MILL MAINTENANCE, LLC
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
OMAHA, NEBRASKA—
Elkhorn Mechanical and Combustion
An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.
NORTHLAKE, TEXAS—
Crown Lift Trucks
An employee was operating a lift truck when it struck a stationary lift truck. His left thumb was pinched between the two lift trucks, resulting in a partial amputation.
VALHALLA, NEW YORK—
Spellman High Voltage Electronics Corporation - Valhalla
An employee was disassembling a pressurized unit using a driver drill. When the unit was disassembled, it caused a kickback from the tube head, causing the drill to strike the employee's left forearm. They sustained a diaphyseal fracture to their left radius and ulna, which required surgery.
LAKE PANASOFFKEE, FLORIDA—
Ring Power Corporation
After repairing a piece of industrial equipment, an employee had brake-cleaning liquid on his gloves. A lighter ignited the liquid, and the employee's hands were severely burned.
More severe injuries in ALABAMA
GENEVA, ALABAMA—
Sysco Gulf Coast, LLC
An employee was traveling down the maintenance aisle of a warehouse on a single-pallet front rider jack. The jack malfunctioned, causing the brakes to apply; the employee fell forward onto the concrete warehouse floor. The employee suffered an injury to the left leg and was hospitalized, requiring surgery.
BESSEMER, ALABAMA—
Norflex, Inc.
An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.
ANNISTON, ALABAMA—
Ampler Pizza II LLC
An employee was shot in the leg with a pistol during an altercation with two people who had entered the store without permission.
ATMORE, ALABAMA—
Birdsong Corporation
An employee was directing a truck driver to a dump site when the truck's peanut trailer slipped off the kingpin. As the trailer fell, a ladder attached to it lacerated the employee's ear. The employee was hospitalized.
ROGERSVILLE, ALABAMA—
Pilgrims
An employee was unloading a forklift from a trailer to the ground. The employee was climbing down the ladder of the trailer when their foot slipped through one of the rungs, causing them to fall backward onto the forklift forks. The employee was hospitalized for fractured ribs.