Contact with hot objects or substances · Thermal burns third degree or higher
At a glance
Federal OSHA recorded a severe workplace injury
at Depot Connect International Tank Wash Facility, 5100 Underwood Rd, PASADENA, TEXAS 77507
on — Thermal burns third degree or higher, affecting the Trunk and other upper extremities.
Final narrative
An employee was working in the tank wash facility and went to turn on a cold-water hose. The steam hose turned on and the employee was burned by steam. He was hospitalized with second- and third-degree burns to his right arm and torso.
Hospitalized Trunk and other upper extremities Steam, vapors nonchemical
An employee pulled out a bucket of hot oil from under the fryer. The employee then stood on the table to clean the back wall. He stepped down into the bucket of hot oil, resulting in third-degree burns to his left leg.
An employee was performing maintenance under a kettle. When he removed a tri-clamp on a transfer line, the hot fat and broth material in the kettle poured out onto his arm. The employee was hospitalized with burns.
After completing a run with an oil distributor truck, an employee was working to return (suction) the hot oil to the tank of the truck. When the employee opened one of the valves, hot oil (approximately 385 degrees) sprayed their face, resulting in first-, second-, and third-degree burns.
An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.
An employee was using a water hose to clean debris out of the outfeed of a log conditioning vat. Water began entering the vat from the adjoining vat through a void in the separation wall at the infeed of the vats. As the employee was exiting the vat he had been working in using the access opening at the outfeed, hot water exiting the access opening entered the top of his protective hip wader. It pooled at the bottom of the wader and burned his left foot and ankle.
More severe injuries in this industry (NAICS 562998)
An employee was performing maintenance on a hopper. The employee's hand was caught in a cylinder pivot point area when the pneumatic cylinder released trapped air. The cylinder crushed the employee's left little finger, causing the partial amputation of the fingertip.
An employee was opening a door to a semi trailer at the facility and his hand was caught between the door and another parked semi. The employee's left index finger was fractured and thumb muscles were injured. The employee was hospitalized and required surgery.
An employee was removing residual meat particles from the sprocket of the crossover conveyor belt in the packing area. While doing so, the conveyor started and his fingers were caught between the metal framework and the belt, resulting in amputations to the middle and ring fingers on the left hand as well as skin damage to the right hand.
An employee was unloading vehicles. While unloading a van, the brakes failed and the vehicle rolled off the car hauler and ran over the employee. The employee was hospitalized for a lower left leg fracture.
An employee was servicing the compactor. They were reconnecting the turnbuckle on a receiver box when the turnbuckle slipped and fell, crushing the employee's left middle fingertip. The employee was hospitalized for surgery.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.