Martin Brower

On April 8, 2025, an employee was unloading 40-pound boxes from a trailer. He fell out of the trailer to the ground about 4 feet below, suffering a lower lumbar fracture.

An employee was unloading product from a truck when they fell off the lift gate to the ground, resulting in broken bones.

An employee was receiving training on how to operate a pallet jack when the employee was struck by the pallet jack, suffering a broken left ankle that required hospitalization.

An employee was operating an electric pallet jack, taking it to be charged. When the employee dismounted the pallet jack, his right foot became caught under the pallet jack, fracturing his right ankle. The employee was hospitalized.

An employee was standing next to his pallet jack when another employee's pallet jack hit him, injuring his left ankle/foot.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.

An employee had been cleaning the work area. While lifting a saw, the employee's index finger was lacerated by the saw blade. A tendon was cut and required surgery.

An employee was installing a hydraulic extension cylinder in a tow truck when their leg was caught between the cylinder and the truck frame. The employee was hospitalized with a broken tibia, which required surgery.

An employee was sorting sucker rods. His right hand was caught in the area where the rod hits up against the frame and his index fingertip was amputated just below the nail.

An employee was operating a rider pallet jack when it struck a stand-up forklift. The forks struck both of the employee's ankles, resulting in hospitalization.

An employee was working to repair a machine with a broken metal stopper. She removed the stopper and used a roll of tape to temporarily secure it. While she was moving it back into place to fix the machine, the residual pressure of the plastic pallets forced the stopper down, resulting in her right thumb becoming stuck between two metal parts. The thumb was amputated.

An employee was changing the battery on his forklift. He removed the forklift's battery plate and exited the battery machine alignment track. The shift lead then went to retrieve a new battery. The employee entered the battery machine alignment track again to unplug the charging cable. The battery changing equipment proceeded forward and pinned the employee against the forklift. The employee was hospitalized with two fractured ribs.

An employee took a picture of the seal and license plate on a delivery truck after loading. The truck then reversed back to the dock and pinned the injured employee against the dock. The employee sustained an abdominal fracture.

An employee was using a hook tool to pull a pallet onto the lift gate of a tractor trailer. The hook detached from the underside of the pallet, causing the employee to fall backward off the lift gate. The employee landed on the concrete parking lot about 5 feet below, suffering fractures to the skull and two thoracic vertebrae.

An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.

An employee was working in the food service warehouse when he experienced chest pain, difficulty breathing, and lost consciousness. The employee sustained carbon monoxide poisoning.

An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.

An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.

An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.