105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

Kleeberg Sheet Metal Inc

Struck by other falling object n.e.c. · Fractures

Federal OSHA recorded a severe workplace injury at Kleeberg Sheet Metal Inc, Yale Chemical Safety Building, NEW HAVEN, CONNECTICUT 06511 on — Fractures , affecting the Arm(s) unspecified.

During ductwork installation, a piece of ductwork was being adjusted to make the next piece fit. The isolation hanger holding the piece fell apart and dropped the piece on an employee who was on a ladder. It caught his hand against the ladder, and his left arm was broken.

Hospitalized Arm(s) unspecified Ducts any material

Kleeberg Sheet Metal Inc

An employee was in the parking lot spotting for a driver that was hooking up a trailer. The employee slipped on ice and fell to the asphalt, resulting in torn ligaments in his knee that required surgery. The employee was hospitalized.

Kleeberg Sheet Metal Inc

An employee was retrieving a tool from his vehicle when the vehicle door closed on his left hand resulting in amputation of the little fingertip.

View Kleeberg Sheet Metal Inc's full OSHA safety record →

RG Professional Carpenter, Inc.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

Rae Corporation

An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.

Red Dot Corporation

An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.

Simon Contractors of South Dakota, Inc.

An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.

RJV Construction

An employee was rigging I-beams. An I-beam slid off the stack of I-beams and fractured the employee's leg.

Channel Sheet Metal, Inc.

An employee was driving a forklift when its right front wheel dropped off a 6-inch curb. The forklift rolled over and trapped him against the concrete surface. He suffered a broken pelvis, ribs, and collarbone, as well as a collapsed lung.

Blackburn's Fabrication, Inc.

An employee was operating a brake press when the top die broke, causing the bottom die to roll out and onto the employee's legs. Both of the employee's legs were crushed below the knee, and both legs were partially amputated. The employee's left leg was also fractured above the knee.

Mason Road Sheet Metal, Inc.

An employee was performing routine maintenance on a shear machine when the machine's foot pedal was engaged and the blade contacted his right middle finger, resulting in a partial amputation.

Rollex Corporation

An employee was helping to tighten down a metal packaging band for shipping. The metal band broke and struck the employee across their face, cutting their left face/eye area. The employee was hospitalized.

Kemlee Manufacturing Inc.

An employee was cutting plywood on a table saw. They went to retrieve a piece of wood and the saw blade partially amputated a fingertip.

Heavy Weight Inc

An employee was checking on a machine outside of the building and removed a cover to clean out a blocked area. His hand was caught by a rotary valve in a dust collection machine. The employee's fingertip was amputated.

Duro Bag

An employee was working to clean a glue roller with a scraper tool. The tool and the employee's left thumb were pinched between two rollers, resulting in a partial amputation.

United Refrigeration Inc

An employee was re-arranging boxes of pipe insulation on a pallet. One of the boxes fell from the pallet and knocked over an upright empty cylinder. The cylinder fell and crushed the tip of the employee's right toe. The employee's toe required surgical amputation.

Michels Power, Inc.

An employee was securing the claw of a grapple truck to the truck bed. His left little finger was caught between the tie down strap and the rub rail of the truck, resulting in partial amputation of the finger.

Parker-Hannifin Corporation

An employee was cutting extruded aluminum framing material using a horizontal band saw. She went to grab a rag in the machine when the rag contacted the blade and pulled her hand in toward the blade, resulting in a partial amputation of the right index finger.