Conagra Brands, Inc.

An employee was called over to the dinner line due to a black substance under the rotary. The employee was cleaning the black substance from the discharge hole of the rotary when their fingers were struck by the rotary cups. The employee sustained amputation injuries to the middle and ring fingers on their left hand.

An employee was reversing a forklift out of the raw meat operation area when her left elbow was caught between the forklift and a stainless steel bollard. The employee sustained multiple fractures to the elbow.

An employee was exiting a room and caught her right thumb in the hinged side of the door, resulting in amputation of approximately two centimeters of her thumb tip.

An employee was inspecting a sorter conveyor. The employee was pulled into the roller, resulting in fractures and degloved skin on the forearm that required hospitalization and surgery. The injury required amputation of the arm below the elbow.

An employee's left-hand fingers were pulled into the chain and sprocket on a horizontal conveyor. All four fingers were lacerated, and the index and little fingers required partial medical amputations.

An employee was inspecting a generator whose radiator was leaking. He slipped, and a fan blade in the generator amputated his thumb and index finger.

A temporary employee turned off a planer machine, opened the housing, and began clearing a jam. The machine's spinning blade caught his right hand and degloved the index finger.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.

A casting machine jammed. An employee's hand was caught in the machine, where a belt line caught and amputated the tip of his finger.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was painting a wall. They fell down three steps and landed on a plastic mop bucket and the floor. The employee was hospitalized with fractures to their right arm and right hip, and required surgery.

An employee was using an electric jack to load a pallet onto a truck when he was struck from behind by a forklift, resulting in a laceration to his right leg.

An employee was performing maintenance on a tray packer. They put a piece of cardboard down onto the belt of the tray packer and stood on the belt. The belt started, causing the employee to lose balance and fall approximately 2 feet. The employee was hospitalized with a fractured ankle and required surgery.

An employee was adding cilantro to the dicing machine when it became jammed. While clearing the jam, the blade amputated approximately 1/2" to 3/4" of his right middle finger.

An employee was cleaning and sanitizing a mixer when the machine was activated. The employee's hand was caught in the machine and he sustained the amputation of his right hand. The employee was hospitalized.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.