OSI Group, LLC

An employee was performing dry cleaning operations on a food forming machine when their left middle finger was struck by a plunger mechanism and they sustained a partial fingertip amputation. The machine was not guarded at the time of the incident.

An employee was chopping bacon with an 8-inch chef knife when they sustained a left middle fingertip amputation through part of the nail.

During cleaning and setup, two employees were reinserting a 5-inch barrel into a riser on a sausage forming machine. The barrel went past its set point and amputated an employee's left little fingertip.

An employee was troubleshooting a problem with a bacon press machine when their left foot was crushed by the hydraulic ram.

An employee was guiding film into a machine that packs frozen materials in cardboard, then wraps it in film and uses heat to seal the product. The chain that pulls the film into the machine caught the employee's right ring finger amputating it at the nail line.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.

An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.

An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.

An employee was rigging I-beams. An I-beam slid off the stack of I-beams and fractured the employee's leg.

An employee was painting a wall. They fell down three steps and landed on a plastic mop bucket and the floor. The employee was hospitalized with fractures to their right arm and right hip, and required surgery.

An employee was using an electric jack to load a pallet onto a truck when he was struck from behind by a forklift, resulting in a laceration to his right leg.

An employee was performing maintenance on a tray packer. They put a piece of cardboard down onto the belt of the tray packer and stood on the belt. The belt started, causing the employee to lose balance and fall approximately 2 feet. The employee was hospitalized with a fractured ankle and required surgery.

An employee was adding cilantro to the dicing machine when it became jammed. While clearing the jam, the blade amputated approximately 1/2" to 3/4" of his right middle finger.

An employee was cleaning and sanitizing a mixer when the machine was activated. The employee's hand was caught in the machine and he sustained the amputation of his right hand. The employee was hospitalized.

An employee fell while moving a water canister, resulting in fractures to four fingers on her right hand.

An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.

An employee was mixing sauce using a sauce barrel mixer when his left little finger was amputated.

An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.

A temporary employee was carrying a nail gun through the warehouse when it hit his leg, activated, and fired a nail into the leg.