Federal OSHA recorded a severe workplace injury
at Sulzer Turbo Services Houston, Inc., Pemex Deer Park Refining, DEER PARK, TEXAS 77536
on — Fractures , affecting the Ankle(s).
Final narrative
Employees were using a forklift equipped with four wire slings to move a 20-foot by 6-foot roofing panel from the work area to the laydown yard. The slings were threaded through the forklift's forks (two slings per fork), and the other ends were secured to the panel with shackles. The forklift was reversing through a bay door opening and the injured employee was applying pressure to a corner of the panel so it would fit through the opening. The load shifted, causing a sling to slide off a fork. The roof panel then fell onto the injured employee's left foot, resulting in a fractured ankle.
Hospitalized Ankle(s) Structural elements n.e.c.
More severe injuries at Sulzer Turbo Services Houston, Inc.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.
An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.
An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.
Two employees were using a scissor lift to install a sign when a gust of wind knocked the scissor lift over. One of the employees fell to the ground, resulting in a broken left shoulder and left hip.
An employee was using a drill press to bore a piece of wood. The drill bit caught the glove on his left hand, resulting in the amputation of his left thumb.
An employee was working to fit two 1-1/2-inch stainless steel spool pieces at a flanged connection to bolt up.
To align the two spool pieces, the top section of pipe (10 feet in length) was rigged using a nylon strap choker, attached to a 1/2-ton chain.
As the employee attempted to move the pipe, the load shifted in the nylon strap, causing the top section of the pipe to drop approximately 1-2 inches, which pinched the injured employee's left index finger in the flanged connection and resulted in an amputation of the finger's distal tip.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.