MuCell Extrusion LLC

An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.

An employee was mixing sauce using a sauce barrel mixer when his left little finger was amputated.

An employee was working on a production line. The employee went to retrieve parts that came out of the parts holder, and their left hand became caught between a chain and a sprocket. Three fingers on the hand were amputated.

An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.

An employee was operating a pad printer. The employee's finger was caught in the printer and they suffered a fingertip amputation. The part of the printer that caught the employee's finger was unguarded at the time.

Employees were using a forklift equipped with four wire slings to move a 20-foot by 6-foot roofing panel from the work area to the laydown yard. The slings were threaded through the forklift's forks (two slings per fork), and the other ends were secured to the panel with shackles. The forklift was reversing through a bay door opening and the injured employee was applying pressure to a corner of the panel so it would fit through the opening. The load shifted, causing a sling to slide off a fork. The roof panel then fell onto the injured employee's left foot, resulting in a fractured ankle.

Two employees were using a scissor lift to install a sign when a gust of wind knocked the scissor lift over. One of the employees fell to the ground, resulting in a broken left shoulder and left hip.

An employee was removing a part from a bending machine. The machine clamp amputated the bottom tip of the employee's right little finger.

An employee was using a drill press to bore a piece of wood. The drill bit caught the glove on his left hand, resulting in the amputation of his left thumb.

An employee was working to fit two 1-1/2-inch stainless steel spool pieces at a flanged connection to bolt up. To align the two spool pieces, the top section of pipe (10 feet in length) was rigged using a nylon strap choker, attached to a 1/2-ton chain. As the employee attempted to move the pipe, the load shifted in the nylon strap, causing the top section of the pipe to drop approximately 1-2 inches, which pinched the injured employee's left index finger in the flanged connection and resulted in an amputation of the finger's distal tip.

An employee fell while exiting a trailer. The employee landed on their left side on the pavement, suffering multiple broken ribs on the left side. The employee was hospitalized.

Two employees were setting up a mandrel in the spindle of a machine. The mandrel was side-shifted while an employee's hand was on the mast of a powered industrial truck. The employee suffered crushing injuries that resulted in amputations to the middle and ring fingertips.

An employee had been loading a double deck press. The employee saw a mold had been sent in with the C-hook still attached on the belly bar. As he went to remove the hook from the mold, his right thumb got caught on the C-hook. The employee's thumb was partially amputated.

An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.

An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.