Struck by other falling object n.e.c. · Amputations, avulsions, enucleations unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Montrose Environmental Group, Inc., 1705 Burt Street, BEAUMONT, TEXAS 77703
on — Amputations, avulsions, enucleations unspecified, affecting the Finger or thumb tip(s), nail(s).
Final narrative
An employee was sampling a fluid catalytic cracking (FCC) unit by opening a valve and placing a proving tube inside to collect the sample. The sample taken is a hot gas mixture. When the sample was collected, the flange came undone and fell due to the pressure. The employee sustained an amputation to their right middle fingertip.
Amputation Finger or thumb tip(s), nail(s) Pipe fittings, collars
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.
An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.
An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.
The employee was working in the back of a micro truck and maneuvering around the materials in the back of the truck. The employee's foot caught on the edge of the truck, causing him to lose balance and fall from the back of the truck to the ground approximately 3.5 to 4 feet below. The employee landed on his feet on the loading dock but rolled his ankle. The employee was hospitalized with a compound fracture of the ankle.
An employee was assisting the operator of a soil sampling rig to collect soil samples. He went to remove soil sampling tooling and the energized equipment cycled. His right index fingertip was amputated including the fingernail.
A truck driver was loading a second roll-off container onto a two-box trailer. He was operating the hydraulic control levers with his left hand, and was holding the D-ring in place on the exterior of the trailer while letting slack out of the winch cable. The employee's right little finger became pinched between the winch cable and the structure of the trailer. The employee required surgical amputation of the distal phalanx.
An employee working at ground level was using a 4-foot angled prybar to position the top panel of an aboveground storage tank. The prybar slipped, causing the employee to fall backward to the ground. He was hospitalized with a fractured right tibia and fibula.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.