Federal OSHA recorded a severe workplace injury
at Industrial Service Corporation, 15 Industrial Drive, HAMILTON, NEW JERSEY 08619
on — Thermal burns degree unspecified, affecting the Ears and facial region unspecified.
Final narrative
A mechanic was working on a drive shaft that had seized. They applied brake cleaner and compressed air to the drive shaft. The employee then used a torch to heat up the area. The torch ignited fumes from the brake cleaner and the mechanic suffered burns to their face.
Hospitalized Ears and facial region unspecified Cleaning and polishing agents n.e.c.
An employee was using a torch to loosen a bolt on a water trailer. Natural gas was present in the water and it ignited, causing a fire. The employee sustained third-degree burns to their upper leg.
An employee had been removing phosphorus pentasulfide while on a scaffold. He was using a non-sparking tool to dislodge the phosphoric material. The employee noticed a flash of flame. He descended the scaffold, but the flash ignited residual phosphorus pentasulfide that was on the outside of the employee's personal protective equipment (PPE). He sustained thermal burns to his right hand and right calf.
An employee was taking a butane gas sample as part of the hydrocarbon refining process. A component disconnected and the butane ignited, resulting in first- and second-degree burns to the employee's forearms and to their face, including their cheeks, chin, and neck.
An employee was troubleshooting a power washer in the field. Because there might have been water in its fuel, he brought it back to the shop and drained about a gallon of fuel from the tank into a plastic container. Some of the fuel spilled onto the floor and ignited. The employee was stomping out the fire when he lost his balance and tripped into a stool, which caused the plastic container to spill more fuel onto the fire. The employee's pants and shirt caught on fire, and he fell, abrading his knee while trying to get through the flames. As well as the knee abrasion, he suffered burns to the left leg and left lower quadrant of the torso. He was hospitalized.
An employee was fueling a gasoline-powered pressure washer with a safety fuel can. During the transfer the fuel ignited, causing a fire. The employee sustained burns to his nose, and his right hand and forearm.
More severe injuries in this industry (NAICS 237310)
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.
A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.
An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.
An employee was working with paving equipment and heard a noise on the opposite side of the machine he was working on. When the machine stopped, the employee went to the opposite side and crouched down to investigate the noise. A mini track loader backed up and drove over the employee's leg. The employee sustained fractures to their lower leg, ankle, and foot.
An employee was installing fence posts when they stepped into a recently dug hole that was not visible due to rainfall. The employee's leg was fractured.
An employee assisted in cleaning material from a conveyor pit. After the pit was cleaned, the employee proceeded to replace metal safety plates to ensure other employees did not fall into the pit. While replacing one of the last plates, the employee mis-stepped and fell approximately 5 feet into the pit. The employee was hospitalized with back/side bruising, elbow bruising, bone bruises, and/or fractured ribs.
An employee was walking on the sidewalk. When they stepped off the curb, they fell to the ground, resulting in fractures to their tibia, fibula, and a metatarsal.