Texana Tank Car

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.

An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.

An employee was working on a platform, raised 6 to 8 feet in the air, to get something off a rack. The employee fell from the platform to the ground and sustained a head injury and injury to multiple body parts.

An employee was preparing to unjam an auger shaft while standing on a forklift-elevated, job-made platform. The employee's wrench slipped off the equipment, causing them to lose their balance and fall. The employee landed on the ground 14 feet below and suffered fractures to the orbital bone, left elbow, and lower back.

An employee was responding to a service request for a cable stripping machine that was making noise and not functioning consistently. While testing its function, the machine contacted the employee s right index fingertip, resulting in a fingertip amputation to the tuft.

An employee was using a handheld cordless electric torque wrench. The tool's reaction arm came into contact with the employee's left hand, causing an amputation to the middle finger above the first knuckle.

On August 6, 2025, an employee was preparing to weld a metal sheet that goes between containers and weighs 800 pounds. The employee was placing a two-foot wooden brace (4 by 4) under the metal, which was being raised by a crane operator using a magnet. The magnet shifted and caused the load to catch the employee's right index fingertip against the wooden brace, resulting in a fingertip amputation.

An employee was climbing up a ladder to the top of a railcar. The employee slipped and fell from the ladder, striking the coupler of the railcar during the fall. This caused the employee's body to shift, and they landed on their head/nose/face. The employee suffered broken ribs, a broken cheekbone, a broken nose, and internal bleeding.

An employee was working to remove a railcar coupler (approximately 400 pounds) from a rail tanker car prior to abrasive blasting. A forklift was used to hold the weight. While attaching a device to the coupler, the last pin holding the coupler was removed. The coupler fell onto the employee's lower right leg, causing a hairline fracture and an open wound that was approximately 1x3 inches in size.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.