DGC Cleaning Services Llc

An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.

An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was placing a board on top of a bundle of steel tubing. A crane was moving a bundle of steel that struck the employee and caught them against another bundle of steel tubing. The employee sustained a crushing injury and hematoma to the right upper leg.

Employees were using a crane to lower large tree stems and branches while removing limbs and branches from the load. This caused the load to shift and strike an employee in the back, resulting in a hematoma on the lower left part of their back and a fractured ankle.

An employee was rinsing a food processing machine at a facility and went to stabilize himself. His left hand contacted the surface of the machine and a guard inadvertently closed, crushing the tip of his ring finger and resulting in an amputation and fracture.

An employee was performing janitorial duties on the 15th floor of a building that was under construction. She began having trouble breathing. The employee was hospitalized with lung irritation caused by dust.

On October 17, 2025, an employee was descending a fixed two-step stool when she slipped, landed on her left leg, and suffered a broken femur. She was hospitalized, requiring surgery.

An employee slipped while getting on a trailer. His chin struck the trailer jack, and he suffered fractures to his jawbone and thyroid cartilage. He was hospitalized, requiring surgery.

A crew was finishing work for the day at a job site. An insulated modular panel (IMP) being used as a door fell on an employee. She suffered a dislocated shoulder, a broken arm, and a gash on her left leg. She was hospitalized, requiring surgery for the arm/shoulder injury.

An employee was troubleshooting the control setup for a variable air volume box above a ceiling. The employee's hand came into contact with an exposed, energized 277-volt wire that had loosened from its terminal on the box's assembly. He was shocked and fell off a ladder. His left hand passed across the ceiling grid and was lacerated. He also suffered an electrical burn to the right hand and was hospitalized.

An employee was assembling a baker type scaffold. He was beginning to transverse down the scaffold, approximately six feet off the ground, when the scaffold tipped over and he fell. The employee was hospitalized with a fractured femur.

An employee was stocking and ordering the meat case on the sales floor when he slipped and fell due to water on the floor. The employee was hospitalized with a fractured ankle and required surgery.

An employee was working on an exhaust fan on the roof when he tripped on a wire and fell to the ground. The employee sustained scrapes on his elbow, and a fractured right knee with a torn ACL. The employee was hospitalized.

An employee was climbing a scaffold when he slipped and fell 10 to 15 feet to the ground. The employee was hospitalized with a fractured ankle.