Injured by object handled by person n.e.c. · Amputations, avulsions, enucleations unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Patterson-UTI Drilling Company LLC, Rig 596, RATLIFF CITY, OKLAHOMA 73481
on — Amputations, avulsions, enucleations unspecified, affecting the Other finger(s) n.e.c..
Final narrative
An employee fell onto a rig floor while a stand of drill pipe was being moved nearby. The employee had just braced himself, putting his hand out in front of him, when the stand of pipe was set down on the floor. It crushed the employee's left ring finger, resulting in an amputation to the finger.
Amputation Other finger(s) n.e.c. Pipes, tubes metal
More severe injuries at Patterson-UTI Drilling Company LLC
On September 18, 2025, an employee was descending stairs on a rig floor when he fell on the third step from the top and landed on his right foot, which then turned inward. The employee suffered a fracture that required hospitalization.
An employee was standing on a piece of equipment called a K-brace, approximately 3.5 feet off the ground. He was working to assemble part of the K-brace. He was driving a metal pin with a sledgehammer and put the sledgehammer on the ground. He then hopped off the K-brace backward and struck the handle of the sledgehammer as he came to the ground. The employee was hospitalized with a laceration to his left buttocks and a fractured tailbone.
An employee was standing on the ground while rolling a pony sub from the forks of a forklift onto a catwalk. The sub shifted and fell approximately two feet onto the top of their right safety boot. The employee was hospitalized with a fractured foot that required surgery.
Two employees were carrying a drill bit and installation tool to the center of a drilling rig floor. One of them slipped and fell, and the drill bit and installation tool landed on his left hand. He suffered an open fracture and partial amputation of the last joint of the little finger, as well as a laceration to the ring finger.
An employee was working on a rig floor while connected to a hoist line that was leaning against a derrick held up by a tugger. The tugger fell and a 5-foot sub pipe struck the employee's head, knocking him over. He stood up quickly and his head struck a catwalk trough. The employee was hospitalized with a concussion and a laceration behind their ear with an indented fracture.
An employee was rolling up the landing gear on his trailer when the handle began to unwind and struck his face, fracturing his jaw. The employee was hospitalized and required surgery.
A maintenance employee was working to place a 120-pound metal screen on top of a machine before installation, with the help of another employee. The injured employee's right ring finger was pinched between the screen and the machine and the fingertip was partially amputated.
An employee was assisting three coworkers with loading a fall protection metal storage cage onto a wooden pallet. Their right index finger was pinched between the pallet and the bottom of the cage, resulting in a fingertip amputation.
An employee was helping another employee load stock material onto a press brake when the stock slipped. The injured employee's right index finger was caught between the press brake die and the stock, resulting in amputation at the first knuckle.
An employee was moving a toolbox from a pallet to the sales floor when his left middle finger got caught between the toolbox and the concrete floor, resulting in a fingertip amputation of the distal digit.
More severe injuries in this industry (NAICS 213111)
An employee was stepping down off a 6-inch containment platform to finish loading his truck, when his right ankle rolled. The employee sustained a fractured tibia and fibula at the right ankle and required surgery.
A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.
An employee arrived on location and loaded a blow-out-preventer (BOP) on a 1-ton flatbed truck. While standing on the flatbed securing the the BOP, the employee stepped into a void/hole on the flatbed surface. This caused him to lose balance and fall off the truck bed with his leg still caught in the hole. As a result, he sustained fractures to his left leg.
An employee was rigging up a location. He was using an Allen wrench to free up rotation and start the drawworks engine manually. The engine rotated and his left little finger became caught between the Allen wrench and the engine. The employee sustained an amputation to his little finger and fractures to his wrist.
An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.
An employee was working in the food service warehouse when he experienced chest pain, difficulty breathing, and lost consciousness. The employee sustained carbon monoxide poisoning.
An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.
An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.
An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.