WINDSOR, COLORADO—
Poudre Construction and Design LLC
Other fall to lower level 6 to 30 feet · Fractures
At a glance
Federal OSHA recorded a severe workplace injury at Poudre Construction and Design LLC, 1992 Seasons Dawn Ct., WINDSOR, COLORADO 80550 on — Fractures , affecting the Trunk and other upper extremities.
Final narrative
An employee was standing on the top of a 6-foot rolling scaffold putting tongue and groove 1 x 6 boards on the bottom of a covered patio when he fell and landed on the concrete patio. The employee suffered head trauma and broken bones in his back and wrist.
Similar incidents · Same event type
SYRACUSE, NEW YORK—
Cashless Tolling Constructors
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
JAMAICA, NEW YORK—
Cornell & Company, Inc.
An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.
CRESTVIEW, FLORIDA—
Anderson Columbia Co., Inc.
An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.
ATLANTA, GEORGIA—
Freeman Expositions, LLC
An employee was working on a platform, raised 6 to 8 feet in the air, to get something off a rack. The employee fell from the platform to the ground and sustained a head injury and injury to multiple body parts.
CANAL WINCHESTER, OHIO—
Faler Feed Store, Inc.
An employee was preparing to unjam an auger shaft while standing on a forklift-elevated, job-made platform. The employee's wrench slipped off the equipment, causing them to lose their balance and fall. The employee landed on the ground 14 feet below and suffered fractures to the orbital bone, left elbow, and lower back.
More severe injuries in this industry (NAICS 236115)
MIDLAND, TEXAS—
Betenbough Homes, LLC
An employee was unloading frameless mirrors from a trailer. When unstrapped, the mirrors fell over onto the employee, who suffered a skull fracture, a brain bleed and blood clot, a broken left ankle, and lacerations.
SEATTLE, WASHINGTON—
Industrial Resources, Inc.
An employee was drilling a hole into the sealed hold of a vessel so a marine chemist could test its atmosphere. Upon drilling the hole, a gas that was under pressure was released and caught fire at the drill motor, where the employee was holding it. The employee was burned.
RED BUD, ILLINOIS—
Erie Construction Mid-West, LLC
An employee was inspecting the attic in a home. The employee stepped off the drop-down attic ladder onto drywall, fell through, and landed on the floor about 10 feet below. He suffered a broken left tibia.
MILTON, WEST VIRGINIA—
Asplundh Construction LLC
An employee went aloft in a bucket truck to install a rubber cover-up for the pole set. He was proceeding to frame and transfer the conductors to the new pole when he sustained electrical burns on his left side, arm, and leg that required hospitalization.
TULSA, OKLAHOMA—
Forza Construction Services
An employee was positioned on a scaffold. They were using a level to adjust a pole and place bricks on the side of a wall. They fell approximately 30 feet from the scaffold to the ground, resulting in fractures to their back, rib, and heel.
More severe injuries in COLORADO
GREELEY, COLORADO—
ABC Supply Company
An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.
BOULDER, COLORADO—
Burke Builders Inc
An employee was cutting cabinet trim using a table saw when four fingers on his left hand were severed, resulting in hospitalization and amputation.
LONGMONT, COLORADO—
Circle Graphics, Inc.
An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.
DENVER, COLORADO—
FLATIRON CONSTRUCTION CORP.
A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.
BURLINGTON, COLORADO—
Takkion OPS Management
An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.