Certainteed Corporation

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.

An employee had been cleaning the work area. While lifting a saw, the employee's index finger was lacerated by the saw blade. A tendon was cut and required surgery.

An employee was installing a hydraulic extension cylinder in a tow truck when their leg was caught between the cylinder and the truck frame. The employee was hospitalized with a broken tibia, which required surgery.

An employee was sorting sucker rods. His right hand was caught in the area where the rod hits up against the frame and his index fingertip was amputated just below the nail.

Employees were at the trucks to leave for lunch. The injured employee was putting the cone back after the crew leader pulled the truck forward from the designated worker parking area. The injured employee then ran back to the truck. As he went to get in the truck, he said the upper thigh area of his leg was hurting. He laid on the ground outside the truck and crew leader could see a bump/bulge in the the injured employee's upper thigh area below his hip. The employee sustained a fractured femur and required surgery.

An employee was helping a contractor unload a delivery of two new dock plates from a trailer onto a forklift. The employee s left index and middle fingers were pinched by the dock plates, resulting in amputations to both fingers above the first joint.

An employee was helping to load a customer's truck. The employee stepped toward a forklift to get paperwork from the driver. The employee's right lower leg and foot were run over by the back tire of the forklift. The employee was hospitalized with fractures to his lower right leg.

An employee was moving wet bundles of shingles on a truck bed, when one of the bundles slipped out of his hands. He tripped over a pallet, fell off the bed of the truck, and landed on his left side. The employee sustained fractures to three ribs, and a displaced iliac fracture.

On August 12, 2025, an employee was loading shingles onto the roof of a new-construction home when be began to suffer from heat exhaustion and dehydration.

An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.

An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.

An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.

Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.

An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.