Other fall to lower level less than 6 feet · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at ATC Drivetrain, LLC, 1001 NW 2nd St, OKLAHOMA CITY, OKLAHOMA 73127
on — Fractures , affecting the Upper arm(s).
Final narrative
An employee inspected a machine to see if water leaking from the roof was affecting it and covered the machine with plastic. The employee was descending a 6-foot A-frame ladder when they slipped and fell to the ground from the third or fourth rung from the bottom. The employee sustained a fractured left humerus.
An employee was operating a cone/spear punch press and went to remove a metal piece when the machine cycled. His thumb got caught between the cut rear section of the converter and the internal parts remaining inside and was crushed. The employee was hospitalized.
An employee was assisting in an inventory count by removing a pallet of goods from the second-to-top shelf of an inventory rack using a forklift. The employee's forklift struck the cross beam of the shelf above and the pallet became unstable. A few boxes fell off the pallet, striking the forklift's protective cage. The employee then exited the forklift to move away from the scene and another pallet fell striking the employee's lower back. The employee sustained an abrasion and hematoma to the lower back.
An employee fell while exiting a trailer. The employee landed on their left side on the pavement, suffering multiple broken ribs on the left side. The employee was hospitalized.
A driver was exiting his vehicle outside the plant gate when his foot slipped on the top step of the truck. He fell to the ground, landed on his left hip and elbow. The employee was hospitalized with a fractured hip/femur.
Two employees were removing a service lift platform from the back of a radar system. While handling the service lift platform, employee 2 was standing on the back of the radar and lost their footing, causing the service lift platform to shift and fall. The injured employee then fell from the top of the platform electronic subsystem (PES) to the floor, approximately 56 inches. The injured employee fractured his left elbow and left hip.
An employee fell from a loading dock to the ground 2-3 feet below. She suffered a compound fracture of the left hip and was hospitalized, requiring surgery.
An employee assisted in cleaning material from a conveyor pit. After the pit was cleaned, the employee proceeded to replace metal safety plates to ensure other employees did not fall into the pit. While replacing one of the last plates, the employee mis-stepped and fell approximately 5 feet into the pit. The employee was hospitalized with back/side bruising, elbow bruising, bone bruises, and/or fractured ribs.
More severe injuries in this industry (NAICS 336350)
An employee had been utilizing a lift assist for assembly. When assembly was complete, the lift assist was hung on a rack behind the employee and it became energized because the trigger got caught. When the employee reached for the lift assist, it sprung up, striking their face. The employee was hospitalized with a facial fracture(s) and a concussion.
An employee was running a steel blanking press. After hearing a rattling noise in a conveyor belt that handled scrap coming out of the press, the employee went to clear a jam on the belt. The belt caught the employee's glove, and the employee's index and middle fingers were amputated.
An employee was operating a cone/spear punch press and went to remove a metal piece when the machine cycled. His thumb got caught between the cut rear section of the converter and the internal parts remaining inside and was crushed. The employee was hospitalized.
An employee was loading a coil of steel into the feeder for a 200-ton steel press when it actuated and his hand became caught in the feed rollers. The employee sustained lacerations and a fracture to his left forearm.
An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.
An employee was working in the food service warehouse when he experienced chest pain, difficulty breathing, and lost consciousness. The employee sustained carbon monoxide poisoning.
An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.
An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.
An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.