Struck by running powered equipment n.e.c. · Concussions
At a glance
Federal OSHA recorded a severe workplace injury
at ZF Chassis Systems Tuscaloosa, LLC, 1200 Commerce Drive, TUSCALOOSA, ALABAMA 35401
on — Concussions, affecting the Brain.
Final narrative
An employee had been utilizing a lift assist for assembly. When assembly was complete, the lift assist was hung on a rack behind the employee and it became energized because the trigger got caught. When the employee reached for the lift assist, it sprung up, striking their face. The employee was hospitalized with a facial fracture(s) and a concussion.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
More severe injuries in this industry (NAICS 336350)
An employee inspected a machine to see if water leaking from the roof was affecting it and covered the machine with plastic. The employee was descending a 6-foot A-frame ladder when they slipped and fell to the ground from the third or fourth rung from the bottom. The employee sustained a fractured left humerus.
An employee was running a steel blanking press. After hearing a rattling noise in a conveyor belt that handled scrap coming out of the press, the employee went to clear a jam on the belt. The belt caught the employee's glove, and the employee's index and middle fingers were amputated.
An employee was operating a cone/spear punch press and went to remove a metal piece when the machine cycled. His thumb got caught between the cut rear section of the converter and the internal parts remaining inside and was crushed. The employee was hospitalized.
An employee was loading a coil of steel into the feeder for a 200-ton steel press when it actuated and his hand became caught in the feed rollers. The employee sustained lacerations and a fracture to his left forearm.
An employee was traveling down the maintenance aisle of a warehouse on a single-pallet front rider jack. The jack malfunctioned, causing the brakes to apply; the employee fell forward onto the concrete warehouse floor. The employee suffered an injury to the left leg and was hospitalized, requiring surgery.
An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.
An employee was directing a truck driver to a dump site when the truck's peanut trailer slipped off the kingpin. As the trailer fell, a ladder attached to it lacerated the employee's ear. The employee was hospitalized.
An employee was unloading a forklift from a trailer to the ground. The employee was climbing down the ladder of the trailer when their foot slipped through one of the rungs, causing them to fall backward onto the forklift forks. The employee was hospitalized for fractured ribs.