Struck by dislodged or detached object(s) · Cuts, lacerations, punctures without injury to internal structures
At a glance
Federal OSHA recorded a severe workplace injury
at Xtreme Aviation LLC, 14900 NW 42nd Ave, OPA LOCKA, FLORIDA 33054
on — Cuts, lacerations, punctures without injury to internal structures, affecting the Thigh(s).
Final narrative
An employee was cutting a bumper guard using an electric cutting grinder when the cutting wheel shattered and lacerated his left thigh. The employee was hospitalized with a 6-inch long and 1-2-inch deep laceration to the inner thigh.
Hospitalized Thigh(s) Machine and tool parts, accessories n.e.c.
An employee was removing a rotary actuator at an outboard flap on an airplane. The actuator moved and cut the employee's left little finger, partially amputating the ball of the finger.
An employee was disassembling the avionics equipment cooling ducting to gain access for a repair. After removing the equipment, the fan motor became energized and suction caused the employee's left hand to contact the fan blades. The employee sustained severe lacerations to their index and middle fingers, as well as their thumb (all at or above the last knuckle). Two fingers were medically amputated.
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.
An employee was using a handheld grinder to cut a bolt. The grinding wheel broke apart and a fragment struck the employee s right hand, causing a laceration to the palm near the little finger.
An employee was operating a brake press when the top die broke, causing the bottom die to roll out and onto the employee's legs. Both of the employee's legs were crushed below the knee, and both legs were partially amputated. The employee's left leg was also fractured above the knee.
A pressurized aircraft nose landing gear strut assembly was being disassembled. The gland nut dislodged under pressure and made contact with an employee's left hand, breaking it.
More severe injuries in this industry (NAICS 488119)
An employee was operating a tug that had been re-tagged due to faulty brakes. As the employee approached the designated parking area, he slowed the tug using the clutch and then exited the tug. He went to stop the tug from colliding with a concrete wall when his right ankle became caught between the tug and a parking stall barrier. He sustained a fractured ankle and was hospitalized.
An employee had just arrived to work and was driving a tug to the gatehouse. The tug ran over chocks while exiting the inbound area, causing the employee to fall to the ground. He was hospitalized with four fractured ribs.
An employee was manually pulling a container from the aft cargo hold of a wide-body jetliner. Their right little finger got pinned between the container and the edge of the cargo door. The employee's finger was partially amputated.
An employee was offloading an airplane flight. After driving a transporter car to place a pallet on a static rack, he got off the transporter to apply the lock and secure the pallet on the rack. The pallet began to roll off the rack and pinned the employee against the transporter. He suffered a broken right leg.
An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.
An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.
An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.
An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.