Rollins Construction LLC

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.

An employee was using a handheld grinder to cut a bolt. The grinding wheel broke apart and a fragment struck the employee s right hand, causing a laceration to the palm near the little finger.

An employee was operating a brake press when the top die broke, causing the bottom die to roll out and onto the employee's legs. Both of the employee's legs were crushed below the knee, and both legs were partially amputated. The employee's left leg was also fractured above the knee.

A pressurized aircraft nose landing gear strut assembly was being disassembled. The gland nut dislodged under pressure and made contact with an employee's left hand, breaking it.

An employee was walking to exit the work area when steel walls fell on them, resulting in fractures.

Employees were working to apply sealant to a customer's leaking foundation. The injured employee was digging out dirt and passing it to another worker. The hole that was being dug collapsed and the injured employee became trapped in dirt/mud from the waist down. The employee sustained a fractured pelvis.

An employee was standing on a concrete wall, stripping concrete forms using a pry bar. The employee fell from the wall to the ground 9 feet below, suffering a fractured back and arm.

An employee was welding a beam when they fell 12 feet from a scissor lift to the ground. The employee sustained fractures to their face, thumb, and both wrists.

The injured employee was team lifting a steel tube from an A-frame dolly using the shoulder-to shoulder method with another employee. They lifted one end of the tube so the A-frame could be wheeled out of the way by a third employee. Once the dolly was clear, they lowered the tube down on top of another tube. After setting the tube down, it slipped off the lower tube and fell. The moving tube pulled the injured employee's glove and his left middle fingertip was caught between the two tubes. The employee sustained an avulsion to their finger.

An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.

The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.

An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.

An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.

An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.