STANCEL CONCRETE INCORPORATED

An employee had just loaded a forklift onto a trailer and was removing tie-down straps from the trailer when the forklift tipped. The employee then fell and sustained fractures of the nose, leg, and ankle, as well as head lacerations.

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.

An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.

An employee was working on a platform, raised 6 to 8 feet in the air, to get something off a rack. The employee fell from the platform to the ground and sustained a head injury and injury to multiple body parts.

An employee was preparing to unjam an auger shaft while standing on a forklift-elevated, job-made platform. The employee's wrench slipped off the equipment, causing them to lose their balance and fall. The employee landed on the ground 14 feet below and suffered fractures to the orbital bone, left elbow, and lower back.

An employee was walking to exit the work area when steel walls fell on them, resulting in fractures.

Employees were working to apply sealant to a customer's leaking foundation. The injured employee was digging out dirt and passing it to another worker. The hole that was being dug collapsed and the injured employee became trapped in dirt/mud from the waist down. The employee sustained a fractured pelvis.

An employee was cutting a tack weld with a grinder when the grinder exploded. The employee sustained lacerations to their right index finger.

An employee was welding a beam when they fell 12 feet from a scissor lift to the ground. The employee sustained fractures to their face, thumb, and both wrists.

The injured employee was team lifting a steel tube from an A-frame dolly using the shoulder-to shoulder method with another employee. They lifted one end of the tube so the A-frame could be wheeled out of the way by a third employee. Once the dolly was clear, they lowered the tube down on top of another tube. After setting the tube down, it slipped off the lower tube and fell. The moving tube pulled the injured employee's glove and his left middle fingertip was caught between the two tubes. The employee sustained an avulsion to their finger.

An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.

An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.

An employee was inspecting a generator whose radiator was leaking. He slipped, and a fan blade in the generator amputated his thumb and index finger.

An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.

An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.