Lucas Tree Expert Company

An employee was installing metal panels on a roof when they fell through a skylight and landed on the ground 40 feet below. The employee sustained injuries to their head and ribs.

Employees were installing components of an elevator from inside the elevator and removed temporary hoisting equipment when the elevator descended from the fourth floor to the pit floor. One employee was hospitalized with fractures to their fibula and a rib, and the other employee was hospitalized with fractures to both feet.

An employee was working 32 feet above the ground in a scissor lift, attaching a camera to a gantry crane. The crane moved and struck the scissor lift, which tipped and fell to the ground. The employee was hospitalized with fractures to his collarbone, humerus, and pelvis. Fall protection was worn at the time.

An employee was descending the side of a scaffold when a rail detached from the scaffold and the employee fell 38 feet to the concrete ground. The employee sustained a fractured pelvis, fractured lumbar vertebra(e), and lacerations.

An employee was laying subflooring on the second floor when they fell through the stairwell about 30-32 feet to the concrete floor below. The employee was hospitalized with head trauma.

An employee was cleaning leaves with a backpack blower when he fell from a ladder, resulting in injuries to his head, neck, and back.

An employee was helping to set up a mulch blowing truck when they were struck by an oncoming vehicle. The employee was hospitalized with a fractured knee, a concussion, and a head laceration; they also received stitches on their arm.

An employee was rappelling down a tree. When he was most of the way down, he fell on the ground and suffered a broken pelvis.

An employee was using a table saw to cut a piece of wood when the saw cut his thumb, index, and middle fingers. His index finger was amputated and he was hospitalized.

An employee was mowing a residential lawn at a client's house. The mower slid on the land and tipped over onto him. The employee was hospitalized with a fractured vertebra in the neck and partial paralysis.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.