Teledyne Benthos, Inc.

An employee was climbing stairs when he felt a pop in his knee due to a torn tendon.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.

An employee was using a handheld grinder to cut a bolt. The grinding wheel broke apart and a fragment struck the employee s right hand, causing a laceration to the palm near the little finger.

An employee was operating a brake press when the top die broke, causing the bottom die to roll out and onto the employee's legs. Both of the employee's legs were crushed below the knee, and both legs were partially amputated. The employee's left leg was also fractured above the knee.

A pressurized aircraft nose landing gear strut assembly was being disassembled. The gland nut dislodged under pressure and made contact with an employee's left hand, breaking it.

An employee had just gone through a roll-up door and closed it. The rope used to pull the door down caught her foot and she fell, breaking her left kneecap.

An employee was retrieving a bottle from inside a permeability plugging tester machine when the machine began moving. The employee sustained a left ring fingertip amputation.

An employee was changing the bottom die on a hydraulic power crimper. Their left thumb was crushed between the two die components when the crimper engaged, resulting in thumb fractures.

A chemist was finishing a reaction. He added paraformaldehyde to a Grignard solution in a 5-liter glass jacketed reactor. The reaction mixture over-pressurized and the reactor shattered, spreading shards of glass throughout the room. The chemist sustained lacerations to the chest and thigh.

At 8:50 a.m. on October 6, 20201, an employee was positioned behind a metal shear to help hold a piece of material about to be cut. As the shearing machine was engaged, its vertically moving backstop pinched the employee's left arm against a table below, in place to catch clippings. The employee suffered broken bones just above the wrist and was hospitalized.

An employee fell while exiting a trailer. The employee landed on their left side on the pavement, suffering multiple broken ribs on the left side. The employee was hospitalized.

Two employees were setting up a mandrel in the spindle of a machine. The mandrel was side-shifted while an employee's hand was on the mast of a powered industrial truck. The employee suffered crushing injuries that resulted in amputations to the middle and ring fingertips.

An employee had been loading a double deck press. The employee saw a mold had been sent in with the C-hook still attached on the belly bar. As he went to remove the hook from the mold, his right thumb got caught on the C-hook. The employee's thumb was partially amputated.

An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.

An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.