Cudd Pumping Services

An employee was standing next to a trailer when an iron stock pipe rolled off the trailer and landed on his right foot, fracturing toes.

At about 3:40 a.m., a frac crew was pumping a stage when a conveyor belt on a sand hulk became clogged. An employee had just removed a clog in the equipment when the belt began to run again and pulled in the employee by the left arm. The employee suffered an injury to the hand and arm and was hospitalized.

A discharge hose failed, striking an employee and causing a laceration and fracture of the right tibia. The employee was hospitalized.

An employee was standing on a piece of equipment to assist in a maintenance task when a second employee inadvertently started the equipment. The injured employees' left foot then became caught and fractured in a rotating piece of machinery. The equipment was unguarded at the time.

An employee was struck by a pipe while attempting to open a bleed line, suffering contusions and broken bones in his torso. He was hospitalized.

An employee pulled out a bucket of hot oil from under the fryer. The employee then stood on the table to clean the back wall. He stepped down into the bucket of hot oil, resulting in third-degree burns to his left leg.

An employee was performing maintenance under a kettle. When he removed a tri-clamp on a transfer line, the hot fat and broth material in the kettle poured out onto his arm. The employee was hospitalized with burns.

After completing a run with an oil distributor truck, an employee was working to return (suction) the hot oil to the tank of the truck. When the employee opened one of the valves, hot oil (approximately 385 degrees) sprayed their face, resulting in first-, second-, and third-degree burns.

An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.

An employee was using a water hose to clean debris out of the outfeed of a log conditioning vat. Water began entering the vat from the adjoining vat through a void in the separation wall at the infeed of the vats. As the employee was exiting the vat he had been working in using the access opening at the outfeed, hot water exiting the access opening entered the top of his protective hip wader. It pooled at the bottom of the wader and burned his left foot and ankle.

An employee had been cleaning the work area. While lifting a saw, the employee's index finger was lacerated by the saw blade. A tendon was cut and required surgery.

An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.

An employee was using a torch to loosen a bolt on a water trailer. Natural gas was present in the water and it ignited, causing a fire. The employee sustained third-degree burns to their upper leg.

An employee had been conducting crane operations. The employee went to stop a piece of oil and gas equipment for tubular running from falling over to the ground. Their right hand was caught between a rolling ladder and the equipment, resulting in fractures to the index and middle fingers. They were hospitalized and the middle finger required surgery.

An employee was working to install a drive belt on a water pump. He was holding the belt on both sides of the pulley, working to route it over the top. As he pulled down with his right hand, the pulley rotated and the belt slid over it, pulling his left little finger between the pulley and the belt. He suffered an amputation to the fingertip as well as a fracture to the ring finger.

An employee was servicing an exterior mounted environmental control unit while on a 10-foot ladder. He pushed through a pre-made knockout hole on the panel. Upon bringing his arm down, a sharp area along the panel frame lacerated the top of his hand. The employee required surgery.

On 7/31/2025, an employee was training to ride an ATV when it went into a draw and she went over the front of the ATV, landing on the ground. The employee sustained a fractured arm.

An employee working as a contracted firefighter was using a bulldozer to push back an active fire line when they became entrapped in flames, resulting in first- and second-degree burns.

An employee was assisting with the delivery of pipe racks to the drilling rig. The driver was releasing the tie-down lock straps that were holding the pipe racks on the trailer. When the last strap was released, one of the pipe racks rolled off the trailer and struck the employee while they were on the passenger side of the trailer bed. The employee sustained an open wound to the hand and fractures to their left leg and spine.

On May 1, 2025, at approximately 11:00 AM, an employee was jump-starting the battery of a forklift and his back went out while he was bending down. The employee was hospitalized with a slipped disc and required surgery.