Compressed or pinched between two stationary objects · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at DIAMOND PLASTICS CORPORATION, 2323 MARSHALL ST., LUBBOCK, TEXAS 79415
on — Amputations, affecting the fingertip(s).
Final narrative
Employee was rebilling pipe. While placing a spacer board between the pipe and pipe pusher, his finger got caught between the two, skinning the tip of his finger.
AmputationFingertip(s)Plastic, PVC, or rubber pipes and tubing
More severe injuries at DIAMOND PLASTICS CORPORATION
At about 2:50 a.m. on January 8, 2024, an employee was changing some tooling when the top of the tooling came down and caught his left index and middle fingers. The index finger was lacerated and broken. The middle finger was medically amputated above the first knuckle.
An employee was changing the water filter on an extruder. The lid, which was hanging from a hook, came loose and fell onto his hand. His right middle finger was amputated.
An employee was sweeping behind a guardrail and stepped on the lower portion of the guardrail when he lost his balance. As he stepped back, his foot became stuck between the guardrail and a transformer, resulting in a compound fracture of left tibia and fibula.
An employee was repositioning a chill adder so that the pig tubs behind it could be removed. The employee lost their balance and their finger was pinched between the chill adder and the pig tub, resulting in a fingertip amputation.
An employee was backing up a stand-up forklift. The vehicle struck a guard and a wooden table. Upon exiting the forklift, the employee's left leg became caught between the table and dock guard, causing a fractured leg.
An employee was working on a shoring scaffold with another employee to strip plywood from cement. The employees threw a 4x4 piece of forming down and it got stuck on the beam of the scaffold. The injured employee went to grab the forming when their left ring fingertip was pinched between it and the beam, resulting in a partial amputation.
An employee was using a torch to trim the foundation for a compressed air tank so the tank would fit in place. His left hand was caught between the tank and the steel bar foundation structure; the hand was crushed and burned.
More severe injuries in this industry (NAICS 326122)
Employees were hooking up a new reel of pipe to be processed into shorter lengths. This process involved routing a winch cable through a haul-off and attaching it to the pipe using a clamp. One employee held the winch cable while another pressed the feed-out button to loosen the cable. The cable tightened and pulled the hand of the employee holding it into a pulley. The employee's right index and middle fingertips were amputated at the first knuckle.
On 8/22/2025, an employee was working to clear a grinder jam. The employee was using a "no-touch tool" to rotate the drum of the grinder. He slipped forward and his right hand contacted a pinch point between the backside of the blade and the grinder housing. The employee's right middle fingertip was partially amputated with bone loss.
At about 1:25 a.m. on August 14, 2025, an employee was operating a 10-inch band saw at a molding machine. The employee was working to cut the sprue off a PVC fitting. The blade snagged on the sprue and pulled his left index finger into the blade, which cut it. The finger was partially medically amputated.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.