Struck by powered vehicle-nontransport, n.e.c. · Soreness, pain, hurt-nonspecified injury
At a glance
Federal OSHA recorded a severe workplace injury
at Office Depot, 2401 Midpoint Drive, EDWARDSVILLE, KANSAS 66111
on — Soreness, pain, hurt-nonspecified injury, affecting the foot (feet), unspecified.
Final narrative
An employee was operating an electric pallet jack. She got off the pallet jack and had her hand on the controls. She accidentally twisted the handle and caused the pallet jack to reverse towards her. The pallet jack ran over her right foot, and then smashed her left foot between a pallet and the jack.
An employee was stocking product was using a three-step ladder. As he was descending, he missed the last step and fell. The employee sustained a fracture to his left femur and hip.
An employee was injured while operating a pallet jack in the store sort area of the warehouse. The employee's leg became caught between the pallet jack she was operating and other equipment. The employee was hospitalized.
An employee was going to fill a pallet with items from the warehouse. He was reaching for the handle of the pallet jack but unintentionally grabbed the throttle, causing the pallet jack to move and pin him against another pallet jack. The employee sustained a leg fracture.
An employee was loading merchandise onto rolling containers that were on a remote-operated order picker. While reorganizing merchandise to prevent top loading, the employee's wireless control device contacted a container and caused the order picker to move forward. The employee's right ring finger was caught between two containers and was amputated above the first knuckle.
The injured employee was operating an elevator at a construction site. He went from the tenth floor to the eleventh floor with a plumber and a scissor lift in the elevator. The plumber was using a remote to operate the scissor lift. As the scissor lift was exiting the elevator, a pipe that was on the scissor lift struck the injured employee's chest. The employee was hospitalized.
An employee was dismantling the engine from a vehicle. The vehicle slid off the loader and struck the employee, pushing him into his toolbox. The employee sustained a broken jaw.
More severe injuries in this industry (NAICS 444190)
An employee was unloading freight from a truck when a stack of doors fell over and knocked the employee to the ground. The employee sustained a fractured femur.
An employee was performing rebar fabrication using a bending machine. The employee's glove became caught in the area where the rebar bend overlaps onto itself. The subsequent bending/cutting caused the two overlapping portions to squeeze together and amputate approximately 1/4" of his left index fingertip.
An employee was building wood detail blocking and a wood member needed to be resized. The employee took the wood member to the table saw and set the fence to the correct size. The employee pressed down on the board to control it when his left little finger contacted the running blade, resulting in an amputation.
An employee was clearing a pipe along a culvert using a motorized plumbing machine. The end of the machine got tangled and stuck in long grass and other debris. The employee went to lift the end of the machine out of the grass and clear the blockage when his hand was pulled into the machine, resulting in a partial amputation and open fracture of his left distal phalanx.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.