Struck by object or equipment, n.e.c. · Crushing injuries
At a glance
Federal OSHA recorded a severe workplace injury
at Denver Transit Constructors LLC, W 64th Ave & Pecos St., DENVER, COLORADO 80221
on — Crushing injuries, affecting the nonclassifiable.
Final narrative
On July 22, 2015, an employee was working inside a trench box, attempting to place dunnage under one side of the trench box to protect utility lines. The excavator bucket was used to lift one end of the trench box so dunnage could be placed underneath that section. The bucket unexpectedly released from the boom of the excavator as it raised a portion of the trench box. The bucket fell into the trench box, striking and crushing the employee who was hospitalized and had several surgeries.
An employee was inspecting a bridge repair project. A gas-powered, walk-behind pavement saw, being used 12 feet away from the employee lunged forward, cutting his left foot. The employee's fourth toe was amputated and he was hospitalized.
An employee had been reviewing an insulated glass unit. The employee was placing the glass unit back in its box when it slipped out of the box and a chipped corner lacerated the employee's left hand.
An employee was on a truck while using a clamp to secure a quartz slab to an A-frame on the truck. A gust of wind pushed the slab onto the employee, resulting in a dislocated right shoulder and wrist.
An employee was shearing off two inches of metal when the metal kicked up and struck his hand. The employee's left ring and middle fingertips were amputated.
An employee was working on a 35,000-pound I.D. fan. As the employee rotated the blades with his foot, the blades continued to spin, lacerating his right foot and amputating a toe.
More severe injuries in this industry (NAICS 237310)
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.
A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.
An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.
An employee was working with paving equipment and heard a noise on the opposite side of the machine he was working on. When the machine stopped, the employee went to the opposite side and crouched down to investigate the noise. A mini track loader backed up and drove over the employee's leg. The employee sustained fractures to their lower leg, ankle, and foot.
An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.
An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.
A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.
An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.