GEORGIA PACIFIC CORPORATION

An employee was rearranging unit stacks inside a trailer. He stepped onto one unit (5.5 feet tall) to push the unit behind it. The employee fell between the two units onto the floor of the trailer, resulting in five broken ribs on the left side and a punctured left lung.

An employee was clearing a fault on her machine when she slipped on preprint corrugated sheets lying on the floor and fell to the concrete floor. She sustained a fractured right hip and a bruised right wrist.

An employee was removing a 6' x 6' cover from a log chipper using a hoist. The chipper disc contacted the cover which then dislodged from the hoist and struck the employee, resulting in lacerations to the head, neck and face and broken teeth.

An employee was repairing a sight glass on a water holding tank and noticed a leaking pipe that needed repair. He stepped onto a 3-inch pipe and his wrench fell, causing him to lose balance. The employee fell onto a mixer motor and landed on the floor. The employee sustained a fractured left wrist, fractured left clavicle, and five fractured ribs.

An employee was helping to remove a tote filled with ink when the tote contacted his left hand and pinched his finger between it and a metal frame, amputating his fingertip.

An employee was operating a machine when a wire pulled his right glove resulting in amputation of the index and middle fingertips.

An employee was grinding chicken when their right index fingertip was caught in the grinder and amputated.

An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.

An employee was passing through a large metal door when the door closed on the employee, resulting in a cracked rib.

An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.

Tools and parts were being lowered to the ground from an elevated platform in a 5-gallon bucket. The rope being used to lower the bucket failed; the tools and parts fell and lacerated the left forearm and upper left leg of an employee on the ground.

An employee was tracking an infeed belt on a scrap hogger when their right arm was caught between the belt and a roller. The arm was broken and the employee's shoulder was dislocated. The employee was hospitalized.

An employee was working to clear a jam from a paper napkin folder. The ram that advanced the napkins pushed the employee's right arm into the side of the machine, causing several lacerations and a hairline fracture.

An employee was troubleshooting overflowing ink on a printer-slotter machine when their right ring fingertip was caught in a guarded roller, resulting in a partial amputation.

An employee was disconnecting wires in preparation to swap out a refiner motor when they contacted energized equipment and sustained an electrical shock. The employee was hospitalized.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.