Pedestrian struck by rail vehicle-transportation incident · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at United Ethanol, 1250 Chicago St., MILTON, WISCONSIN 53563
on — Amputations, affecting the foot (feet), n.e.c..
Final narrative
An employee suffered the amputation of his right foot when it was caught under a rail car.
HospitalizedAmputationFoot (feet), n.e.c.Rail car(s)-unattached to locomotive
On December 4, 2023, an employee was helping to move a hopper car. He was climbing the stairs to go to the other side of the hopper car when he slipped. His right foot went under the hopper car's wheel and a toe was amputated.
An employee was working between railcars on an active railroad track to connect the airbrake. Another employee moved the railcars, striking and running over the employee resulting in amputation of both legs.
On March 25, 2022, an employee had just detached a string of empty rail cars away from some loaded cars. The string of detached cars was being taken ahead, and the employee began pulling the knuckle of a rail car into the open position. The string of detached cars then momentarily came back, and the employee was pinched between two cars. The employee suffered a broken right hip and was hospitalized.
At about 8:40 p.m., two employees (a groundsman and a switchman) were working in a rail yard, setting rail cars to be released from the site. The groundsman was watching the switchman connect an end-of-train device on the string of rail cars. While he was on the adjacent track, a locomotive on that track moved forward and struck him, knocking him over, injuring his right foot, and amputating his left leg above the knee.
On June 25, 2020, an employee was acting as a groundman to assist the locomotive driver in staging cars in the blast building. As the railcar was moving past a beam that is part of the building, the employee became pinned between the beam and the railcar and sustained a fractured pelvis.
More severe injuries in this industry (NAICS 325193)
An employee was backing up a forklift when the frame of the forklift clipped the wall. The employee's right little finger was pinched between the wall and the forklift, resulting in amputation.
An employee was removing contaminants from a low point drain on an ammonia line through a hose and into a container of water. A release of pressure from the end of the hose exposed the employee to anhydrous ammonia, resulting in chemical burns to his face, arm, and chest as well as ammonia inhalation. He was hospitalized.
At about 7:00 a.m. on February 11, 2025, an employee was troubleshooting a system that had failed to start. Suspecting a tripped breaker and intending to test the system's motor leads, he hooked up an insulation resistance tester. The side of the breaker the tester was hooked up to was still energized, resulting in an arc flash. The employee was hospitalized with second-degree burns to his face and right arm.
An employee was preparing hopper rail cars for loading. The employee fell from the platform used to access the rail car lids, landing in an empty hopper and suffering broken ribs.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.