Direct exposure to electricity, 220 volts or less · Electrical burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Eagle Equipment Corporation, 401 Old Route 13, BRISTOL, PENNSYLVANIA 19007
on — Electrical burns, unspecified, affecting the hand(s), unspecified.
Final narrative
On 9/24/15, an employee was doing electrical service work to the motor of a vertical cardboard baler. The power to the motor was not turned off at the time. He received an electric shock when he grabbed the live 208 power cord and sustained burns to his hands, requiring hospitalization.
An employee was setting up music for a fitness class. As the employee plugged their personal device into the outlet, she was shocked. The employee experienced pain in her left side, mainly in her arm and head.
Two employees were testing the phase voltage of the 208 volt bus bar circuit. An arc flash occurred during the testing. One employee suffered burns to the face, neck, and hands. Another employee suffered burns to his arm.
An employee was sorting sucker rods. His right hand was caught in the area where the rod hits up against the frame and his index fingertip was amputated just below the nail.
An employee was using a powered miter saw to cut 2x4's. The saw blade hit something inside a board (possibly a hidden nail) and jumped, causing a laceration to the employee's left forearm. The employee was hospitalized with soft tissue and tendon injuries that required surgery.
A crane had been used to set a steel plate on a steel frame. An employee was trying to remove a clamp from the plate when the plate fell and crushed the tip of his left little finger. The employee sustained a fingertip amputation.
An employee was operating a scissor lift, raised to a height of about 15 feet, to inspect an overhead crane rail. The crane itself was being moved. Its hook swung into the scissor lift s arms, causing the lift to tip over onto its side, which in turn caused the lift and the employee to fall to the floor. The employee suffered injuries including broken ribs, spinal fractures, scapula fractures, and internal injuries.
A technician was operating a crane hoist to lift/remove a cylinder head from the main engine (port). The load was lifted at an angle, causing the cylinder head to get stuck on the cylinder head studs. When it became free from the studs, the cylinder head swung. It struck the technician and caught them against the cabinet door. This resulted in an amputation of their left index fingertip at the distal knuckle.
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.
An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.
An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.