Direct exposure to electricity, greater than 220 volts · Third or fourth degree electrical burns
At a glance
Federal OSHA recorded a severe workplace injury
at Wheelabrator Westchester, 1 Charles Point Avenue, PEEKSKILL, NEW YORK 10566
on — Third or fourth degree electrical burns, affecting the hand(s), unspecified.
Final narrative
An employee was closing a 480 volt disconnect switch when it arc flashed and caused third degree burns to the right hand and first degree burns to the face.
An employee was installing a ground wire to a power transmission pole. The ground wire contacted an energized portion of a cut-out, causing an arc-flash. The employee was hospitalized with second degree burns to their chest and arms.
An employee was connecting a utility transformer for underground service to a home. The employee's impact drill went across two connection bars with 240 volts of potential, creating an arc flash. The employee sustained burns to the face and eyes due to the arc flash and molten aluminum.
On December 15, 2023, at 9:15 AM, an employee was changing 60-amp fuses in a 480-volt panel when an arc flash occurred. The employee was hospitalized with burns to both hands.
An employee was performing preventative maintenance on a deflation fan, belt, and pulley. While working on the fan, the rotor in the fan unexpectedly began to spin due to the activation of a damper within the baghouse. The spinning of the fan caused a belt pulley to begin spinning, which made contact with the employee's hand, resulting in an amputation to the right middle fingertip.
An employee was backing up a skid steer from a fuel tank after refueling and struck a parked excavator, resulting in an avulsion injury to their upper right leg.
An employee cleaned out an ash pit. He then opened a door to another part of the machine and began putting a metal rod in the machine. The rod became jammed and struck the right side of the employee's head and face. He fell to the ground and lost consciousness. The employee was hospitalized with fractures to the jaw and orbital bone, and multiple lacerations.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.
An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.