Ignition of vapors, gases, or liquids · Heat (thermal) burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at US Steel, PO Box 878, DRAVOSBURG, PENNSYLVANIA 15034
on — Heat (thermal) burns, unspecified, affecting the arm(s), unspecified.
Final narrative
An employee was working in the OCA department attempting to light the OCA furnace with a butane lighter. There was a suspected gas leak that ignited and burned the employee's right arm.
An employee was moving a table with a glass top. When she picked up the table, she leaned it toward her and the glass fell off the top of the table and onto her big toe, amputating the tip.
An employee was cleaning a cordless drill. As they applied brake fluid to the drill and pulled the trigger, the fluid ignited. The employee suffered burns to the face, hands, and arms.
An employee was spraying glue to the floor of an enclosed cargo trailer. The fumes made contact with the heater causing a flash fire. The employee suffered burns to their face and right hand.
An employee was replacing a valve in the gas line to the fryer. The shutoff valve malfunctioned resulting in a gas leak that then ignited. The employee sustained burns requiring hospitalization.
An employee was unloading metal from two drums on a pallet. The employee removed the lid from the second drum and the drum fell over onto his ankle. The employee sustained a fractured ankle.
An employee was working with team members on the pouring line, casting a sand mold. Molten metal entered the employee's personal protection suit and severely burned his left leg, calf, and ankle.
An employee was jointing a board with a jointer. The board jumped when it came into contact with the jointer's cutter head, and the jolt caused the employee's left hand to slide between the board and the guard and come into contact with the cutter head. He suffered lacerations/partial amputations to the middle, ring, and index fingers.
An employee was turning off a gas valve when he bumped into a die brush and struck the spinning die. The die pin struck him on the back, resulting in contusions, abrasions, and a severe laceration to his back that required hospitalization and surgery.
At 11:45 a.m. on June 13, 2025, an employee of Staley Steel, LLC, was performing preventive maintenance on an overhead crane. While he was holding a grease gun hose and nozzle, he contacted electrical components inside an electrical box. He suffered a first-degree electrical burn on the palm of the left hand, as well as pain up his left arm to the shoulder, and was hospitalized.
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.
An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.
An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.