Struck against moving part of machinery or equipment · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Dana Holding Corporation, 1040 Center Ave., POTTSTOWN, PENNSYLVANIA 19464
on — Amputations, affecting the fingertip(s).
Final narrative
An employee attempted to fault a pin motor machine near the point of operation. His finger made contact with a machine part, and his left index fingertip was amputated.
An employee was walking to assist a coworker on another machine when he tripped over a pallet strap that was on the floor and fell to the ground, breaking his femur and requiring hospitalization.
An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.
An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.
An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.
An employee had been utilizing a lift assist for assembly. When assembly was complete, the lift assist was hung on a rack behind the employee and it became energized because the trigger got caught. When the employee reached for the lift assist, it sprung up, striking their face. The employee was hospitalized with a facial fracture(s) and a concussion.
An employee inspected a machine to see if water leaking from the roof was affecting it and covered the machine with plastic. The employee was descending a 6-foot A-frame ladder when they slipped and fell to the ground from the third or fourth rung from the bottom. The employee sustained a fractured left humerus.
An employee was running a steel blanking press. After hearing a rattling noise in a conveyor belt that handled scrap coming out of the press, the employee went to clear a jam on the belt. The belt caught the employee's glove, and the employee's index and middle fingers were amputated.
An employee was operating a cone/spear punch press and went to remove a metal piece when the machine cycled. His thumb got caught between the cut rear section of the converter and the internal parts remaining inside and was crushed. The employee was hospitalized.
An employee was loading a coil of steel into the feeder for a 200-ton steel press when it actuated and his hand became caught in the feed rollers. The employee sustained lacerations and a fracture to his left forearm.
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.
An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.
An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.