PLANTSVILLE, CONNECTICUT—
GIBBS WIRE & STEEL COMPANY, INC.
Struck by falling object or equipment, n.e.c. · Cuts, lacerations
At a glance
Federal OSHA recorded a severe workplace injury at GIBBS WIRE & STEEL COMPANY, INC., 84 METALS DRIVE, PLANTSVILLE, CONNECTICUT 06479 on — Cuts, lacerations, affecting the foot(feet) and leg(s), n.e.c..
Final narrative
An employee was moving a metal coil from one part of a metal slitting machine to another. The metal coil sliced through the sling being used and lacerated the employee's right shin and foot.
Similar incidents · Same event type
PORT ALLEN, LOUISIANA—
Performance Contractors, Inc.
An employee was moving a piece of an I-beam for welding when it rolled off the cribbing. The employee went to catch it when it fell and crushed the employee's finger, resulting in a partial amputation.
KIRKSVILLE, MISSOURI—
WIRECO WORLDGROUP, INC.
An employee was helping to disassemble large reels used to store steel wire when a 264-pound flange from the reel fell over onto the employee's left leg. The employee sustained multiple fractures to their leg and ligament injuries to the lower leg.
GREENSBURG, PENNSYLVANIA—
Owens & Minor - Pittsburgh Distribution Center
The injured employee was putting away materials on the warehouse floor as a co-worker was pushing a pallet onto a nearby shelf. The pallet knocked another pallet forward, causing it to fall onto the injured employee's shoulders. The employee suffered fractures in their right and left knees and ankles.
FORT BLISS, TEXAS—
Retro Tech Systems
Employees were moving a single man lift into a building and reclining the lift to position it to fit through the door. The lift shifted and fell, causing the employee to sustain fractures to the left tibia and fibula. The employee was hospitalized and had surgery.
ORLA, TEXAS—
Creston Energy Group
An employee was moving a light tower so it could be hitched to a truck. He grabbed the tongue of the trailer hitch on the light tower to slide it to the left. The tongue jack fell off, causing the light tower tongue to drop on the employee's right hand. The employee's middle fingertip was amputated.
More severe injuries in this industry (NAICS 423510)
PITTSBURGH, PENNSYLVANIA—
Triad Metals International
A load of steel angles was being lowered when the lifting chain hit the load, causing it to slide toward an employee. An angle slid and pinched the employee, catching both of their legs between the beams and an angle. The employee suffered two fractured legs.
BEDFORD PARK, ILLINOIS—
Ryder System Inc.
An employee was on the deck of a trailer helping a customer unload tubes. The employee was working to place a cargo strap on the remaining tubes using a winch bar when it slipped off the tubing, causing him to lose his balance and fall headfirst onto the asphalt lot below. The employee suffered a contusion on his forehead, resulting in hospitalization.
SARASOTA, FLORIDA—
EASTERN METAL SUPPLY, INC.
An employee and a customer were unloading two rectangular tubes. The tubes were wrapped together. The plastic wrap was cut so that one tube could be picked up. As the employee was lifting the top tube, the other tube (still connected to the top tube) came down onto his hand and broke two of his fingers. He was hospitalized.
HOUSTON, TEXAS—
TEXAS PIPE AND SUPPLY COMPANY
An employee was assisting as a forklift got pipe from a pipe rack. The employee was on one of the forklift's forks as it was raised to the top of the rack, a height of about 15 feet. He fell to the ground and suffered a dislocated and fractured right elbow.
HAMILTON, OHIO—
United Performance Metals, LLC
On September 23, 2025, at approximately 7:43 p.m., an employee was using a knife to cut poly banding from a metal coil. The knife slipped, causing a laceration to the inside of their left arm at the elbow joint. The employee was hospitalized and required surgery to repair a damaged vein.
More severe injuries in CONNECTICUT
CHESHIRE, CONNECTICUT—
Heavy Weight Inc
An employee was checking on a machine outside of the building and removed a cover to clean out a blocked area. His hand was caught by a rotary valve in a dust collection machine. The employee's fingertip was amputated.
MERIDEN, CONNECTICUT—
Duro Bag
An employee was working to clean a glue roller with a scraper tool. The tool and the employee's left thumb were pinched between two rollers, resulting in a partial amputation.
HARTFORD, CONNECTICUT—
United Refrigeration Inc
An employee was re-arranging boxes of pipe insulation on a pallet. One of the boxes fell from the pallet and knocked over an upright empty cylinder. The cylinder fell and crushed the tip of the employee's right toe. The employee's toe required surgical amputation.
SOUTH WINDSOR, CONNECTICUT—
Michels Power, Inc.
An employee was securing the claw of a grapple truck to the truck bed. His left little finger was caught between the tie down strap and the rub rail of the truck, resulting in partial amputation of the finger.
NORTH HAVEN, CONNECTICUT—
Parker-Hannifin Corporation
An employee was cutting extruded aluminum framing material using a horizontal band saw. She went to grab a rag in the machine when the rag contacted the blade and pulled her hand in toward the blade, resulting in a partial amputation of the right index finger.