Federal OSHA recorded a severe workplace injury
at Hornady Manufacturing , 3625 W Old Potashy Hwy, GRAND ISLAND, NEBRASKA 68803
on — Cuts, lacerations, affecting the whole body.
Final narrative
An employee was operating the Pierce and Prime Line. A primer got jammed in the line and the employee used a tool to try and unjam the line. The tool set off the primer and the adjacent primers causing a minor explosion. The employee was hospitalized with abrasions and lacerations to their face and body.
HospitalizedWhole bodyMetal, woodworking, and special material machinery, n.e.c.
An employee was sitting in the cab of the truck while waste oxidizer was being offloaded. The waste reacted with the receiving tank and an explosion occurred in the tank. Fire traveled through the hose to the tanker truck, causing it to explode. The employee jumped from the burning truck and was hospitalized with burns to his face, chest, and arms.
An employee was installing piping and valves for fire protection systems in the vicinity of an electrical meter outside of a new warehouse. The meter exploded, causing burns to the employee's face and arms.
An employee was pouring molten aluminum into a drain pot. The aluminum touched moisture at the bottom of the drain pot and an explosion occurred. The employee sustained burns to their face, hands, and legs.
An employee was operating an oxygen-deficient oven that required manual ignition to make charcoal from wood. As the oven was opened, oxygen was introduced to the environment, resulting in an explosion. The employee sustained head trauma as well as fractures to the arms and legs.
An employee was setting up the electrical parts for a fireworks display. They were inserting an e-match when it generated friction with something else. A 3-inch firework shell ignited, injuring the employee's hand and head.
More severe injuries in this industry (NAICS 332994)
An employee was clearing a firearm that had a jam in it. To disassemble the firearm, the employee was required to pull the trigger to remove the slide. During this process, the firearm discharged and the employee suffered a bullet wound to his left hand.
An employee was manually adding soda ash into a tank of heated water while on a mobile ladder. The fluid in the tank began to boil over the sides. The employee went to exit the mobile ladder to avoid the boiling liquid that was beginning to contact their lower legs. The employee lost balance and fell approximately 4 feet to the concrete below. The employee was hospitalized and had surgery for a dislocated left knee and thermal burns to the lower portion of both legs.
An employee was changing the bit on a horizontal gun drill. The wrench slipped while tightening a collet and the employee's left little finger was fractured and partially amputated.
An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.
An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.
An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.
An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.