Contact with hot objects or substances · Second degree heat (thermal) burns
At a glance
Federal OSHA recorded a severe workplace injury
at Affinity Chemical, 9978 FM 3129, QUEEN CITY, TEXAS 75572
on — Second degree heat (thermal) burns, affecting the upper and lower limb(s).
Final narrative
An employee was working with hot aluminum sulfate. During the reaction portion of the aluminum sulfate process, the agitator was turned on, causing the aluminum to boil too fast and crack the lid over the sulfate. The hot aluminum sulfate spilled onto the employee, causing second degree burns to the foot and the back of the right arm.
HospitalizedUpper and lower limb(s)Molten or hot metals, slag
An employee connected a steam line to a hose to clean equipment when the fitting broke loose. They were struck by steam in the left inner thigh, resulting in burns that required hospitalization.
An employee was making tea when she noticed tea grinds were collecting on the side and water was no longer dripping through the funnel. The employee was checking the funnel when boiling water and tea grinds spilled onto the left side of her body. The employee sustained burns to her neck, back, and arm.
An employee had turned off the ball valve on a waterpipe system and was removing the plug when the coupling system attached to the strainer came apart. Hot water sprayed on his arm and back, resulting in first- and second-degree burns that required surgery.
An employee was using a shovel to remove waste vermiculite from molten zinc. The metal had been placed in a bin and partially hardened. The employee broke through the partially hardened metal; still-molten metal flowed to the employee's steel-toed right boot and entered through the cloth boot tongue. The employee suffered a third-degree burn to the right foot and was hospitalized.
More severe injuries in this industry (NAICS 331524)
An employee was grinding raw couplings on a belt sander to shave off excess material left by the manufacturing process. The employee's right hand slipped while he was pressing a part to the sander, causing his right thumb to come into contact with the sanding belt. The thumb was lacerated and broken, and the employee was hospitalized, requiring surgery.
An employee was buffing a corner casting when the rotating belt contacted her right hand, resulting in an amputation of the first segment of her right thumb.
An employee was assembling boilers, which involved stacking the flat sections of boilers on top of one another and pushing them down a non-powered roller line. While the employee was pushing a stack onto the next set of rollers, the stack became crooked. The employee went to pull back the stack to straighten it when their finger was pinched by a roller. The employee sustained a partial amputation to their left ring fingertip.
On June 25, 2025, at 7.30 a.m., an employee was using a remote-controlled crane to change a die in a 2,600-ton press. They were releasing crane cables from the die when one cable did not release, causing the die to lift and pin the employee between the press and the die. The employee suffered a closed non-displaced fracture of the pelvis.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.