105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

Car Tech LLC

Struck by suspended or swinging objects n.e.c. · Fractures

Federal OSHA recorded a severe workplace injury at Car Tech LLC, 600 Car Tech Drive, OPELIKA, ALABAMA 36801 on — Fractures , affecting the Pelvis.

On June 25, 2025, at 7.30 a.m., an employee was using a remote-controlled crane to change a die in a 2,600-ton press. They were releasing crane cables from the die when one cable did not release, causing the die to lift and pin the employee between the press and the die. The employee suffered a closed non-displaced fracture of the pelvis.

Hospitalized Pelvis Dies, molds, patterns

Car Tech LLC

An employee was operating a projection welding press when the weld bit contacted her left hand, causing an amputation of the index fingertip.

View Car Tech LLC's full OSHA safety record →

Ardent Mills

An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.

Concrete Industries Nebraska City

An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.

Cives Steel Company New England

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

Hanna Steel Corporation

An employee was placing a board on top of a bundle of steel tubing. A crane was moving a bundle of steel that struck the employee and caught them against another bundle of steel tubing. The employee sustained a crushing injury and hematoma to the right upper leg.

Tri-State Tree Service LLC

Employees were using a crane to lower large tree stems and branches while removing limbs and branches from the load. This caused the load to shift and strike an employee in the back, resulting in a hematoma on the lower left part of their back and a fractured ankle.

Parrish Enterprises

An employee was grinding raw couplings on a belt sander to shave off excess material left by the manufacturing process. The employee's right hand slipped while he was pressing a part to the sander, causing his right thumb to come into contact with the sanding belt. The thumb was lacerated and broken, and the employee was hospitalized, requiring surgery.

Cast Products Inc

An employee was buffing a corner casting when the rotating belt contacted her right hand, resulting in an amputation of the first segment of her right thumb.

Boyertown Foundry Co.

An employee was assembling boilers, which involved stacking the flat sections of boilers on top of one another and pushing them down a non-powered roller line. While the employee was pushing a stack onto the next set of rollers, the stack became crooked. The employee went to pull back the stack to straighten it when their finger was pinched by a roller. The employee sustained a partial amputation to their left ring fingertip.

Car Tech LLC

An employee was operating a projection welding press when the weld bit contacted her left hand, causing an amputation of the index fingertip.

STAHL SPECIALTY COMPANY

An employee was clearing a jam of aluminum castings on the shaker conveyor belt. When they removed the casting causing the jam, the shaker hammer engaged and caught their right little finger. The employee sustained an amputation of the finger between the first and second knuckles.

Sysco Gulf Coast, LLC

An employee was traveling down the maintenance aisle of a warehouse on a single-pallet front rider jack. The jack malfunctioned, causing the brakes to apply; the employee fell forward onto the concrete warehouse floor. The employee suffered an injury to the left leg and was hospitalized, requiring surgery.

Norflex, Inc.

An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.

Ampler Pizza II LLC

An employee was shot in the leg with a pistol during an altercation with two people who had entered the store without permission.

Birdsong Corporation

An employee was directing a truck driver to a dump site when the truck's peanut trailer slipped off the kingpin. As the trailer fell, a ladder attached to it lacerated the employee's ear. The employee was hospitalized.

Pilgrims

An employee was unloading a forklift from a trailer to the ground. The employee was climbing down the ladder of the trailer when their foot slipped through one of the rungs, causing them to fall backward onto the forklift forks. The employee was hospitalized for fractured ribs.