Direct exposure to electricity, greater than 220 volts · Electrical burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Michels Corporation, 8210 Jericho Rd. , WEEDSPORT, NEW YORK 13166
on — Electrical burns, unspecified, affecting the hand(s), unspecified.
Final narrative
An employee in a bucket truck was dismantling powerlines when he was electric shocked, suffering burns to both hands. He was hospitalized overnight.
An employee was manually unloading sections of counterweight pipe. Each pipe had swiveling D-rings mounted on the ends to be used for lifting the pipes with slings. The employee's finger got caught between a D-ring and a pipe resulting in a partial finger amputation.
An employee was installing/winding a rope on a four-drum, motorized rope puller. The employee's right little finger was caught between the rope and the drum, and 1/2 inch was amputated from the tip of the finger.
An employee was attempting to remove a rock that had jammed a mechanical gate on a batch plant hopper and conveyor. When the rock became free, the gate snapped shut, pinching the employee's hand and fingers between the gate and the stop point of the gate. Four fingers were amputated at the second joint of the knuckles.
An employee was installing a ground wire to a power transmission pole. The ground wire contacted an energized portion of a cut-out, causing an arc-flash. The employee was hospitalized with second degree burns to their chest and arms.
An employee was connecting a utility transformer for underground service to a home. The employee's impact drill went across two connection bars with 240 volts of potential, creating an arc flash. The employee sustained burns to the face and eyes due to the arc flash and molten aluminum.
On December 15, 2023, at 9:15 AM, an employee was changing 60-amp fuses in a 480-volt panel when an arc flash occurred. The employee was hospitalized with burns to both hands.
An employee was acting as a spotter for a forklift operator. While its forks were being raised, the forklift came into contact with a power line. The employee was touching the forklift's metal frame at the time and was shocked on the left palm. The employee suffered burns to both the left palm and the sole of the left foot.
An employee was working as a fire watch. The employee was exposed to anhydrous ammonia and was not able to see while climbing down a ladder due to eye irritation. The employee fell and was hospitalized for a broken ankle.
An employee was standing on the ground awaiting the lowering of a pipe. After the pipe was lowered to the ground by a skid steer, it rolled and struck the employee's left leg. The employee was hospitalized with a fractured leg.
An employee was tightening a gas pipe with a wrench when the wrench slipped from his hand. The employee's arm then hit a metal cross-brace, resulting in a lacerated arm.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.
An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.