Guichard Operating Company, L.L.C.

An employee was on top of a 2-by-4 purlin installing rafters. The purlin broke and he fell to the ground about 16 feet below, suffering a broken left femur.

An employee was working in a boom lift to help tear down a building. The employee stepped out of the boom lift and onto one of the trusses when the building collapsed, causing the employee to fall approximately 17 feet to the ground below. The employee sustained fractures to the wrist, hand, ribs, and face.

An employee was climbing a power line pole when the pole broke at ground level while the employee was approximately 20 feet up. The employee rode the pole to the ground and sustained 12 broken ribs, a broken collarbone, and a punctured lung.

An employee was on a pallet that was being lifted by a forklift to a height of 20 feet. The pallet broke and the employee fell to the warehouse floor sustaining fractures to their nose, ribs, and ankle.

An employee was performing tuckpointing while on a swing-stage scaffold. The rope on the scaffold broke and the side of the scaffold fell 20 feet to the ground. The employee impacted the ground and sustained a broken ankle that required hospitalization and surgery.

An employee was stepping down off a 6-inch containment platform to finish loading his truck, when his right ankle rolled. The employee sustained a fractured tibia and fibula at the right ankle and required surgery.

A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.

An employee was working to remove a stuck fish tool from a drill shoe. Their thumb was struck by a hammer, resulting in amputation.

An employee arrived on location and loaded a blow-out-preventer (BOP) on a 1-ton flatbed truck. While standing on the flatbed securing the the BOP, the employee stepped into a void/hole on the flatbed surface. This caused him to lose balance and fall off the truck bed with his leg still caught in the hole. As a result, he sustained fractures to his left leg.

An employee was rigging up a location. He was using an Allen wrench to free up rotation and start the drawworks engine manually. The engine rotated and his left little finger became caught between the Allen wrench and the engine. The employee sustained an amputation to his little finger and fractures to his wrist.

A driver was exiting his vehicle outside the plant gate when his foot slipped on the top step of the truck. He fell to the ground, landed on his left hip and elbow. The employee was hospitalized with a fractured hip/femur.

A security employee was responding to an urgent call from staff regarding a violent patient. The employee tripped and fell on the floor outside of the stairwell. The employee sustained a closed head injury, contusion of the cerebrum without loss of consciousness, and a closed fracture of the distal end of the right radius.

A security employee was holstering her firearm when the gun discharged a bullet into her right leg. The employee was hospitalized.

A temporary employee was testing an electrical starter motor. He was placing tape on the starter while the breaker was not engaged, but the starter sent an arc flash that burned his hands and stomach.

An employee was walking on a sidewalk and stubbed his toe on an elevated portion of concrete, causing him to trip and fall. The employee's right knee was dislocated.