CenturyLink

An employee was working at mid-span between two telephone poles (that is, on a ladder set between the poles and designed to fit between them). The ladder slipped and the employee fell to the ground about 12 feet below, landing on his feet and shattering both heels.

An employee was walking in an office, lost balance, and fell resulting in a hip injury.

An employee had been pulling cable and was hospitalized for heat related illness.

An employee had been using a bucket truck to repair a telecommunications cable at a customer's residence. The employee completed the job and got down into the truck bed from the bucket itself, and was then stepping off the platform at the rear of the truck when he missed a step, lost balance and fell from the back of the truck to the ground approximately 4-5 ft below. The employee landed on his tool belt and the right side of his lower back. He was hospitalized with four fractured vertebrae in the lower back.

An employee was running wire while standing on a stepladder. The employee slipped and fell 4 feet to the ground, suffering a broken femur.

An employee was walking down the hallway when they tripped and fell to the floor, fracturing their right wrist.

An employee was walking down the hall to retrieve a vacuum when they stumbled and fell to the floor. The employee suffered wrist bruises and a kneecap fracture that required surgery.

An employee was carrying furniture backward during a delivery when he tripped and broke his right ankle.

An employee was installing a compressor piston. He tripped and fell backward while the piston was in his lap. As he landed, the little finger of his left hand became caught between the piston and compressor piping resulting in a partial amputation of the fingertip. The employee required stitches and the fingertip was reattached.

An employee was doing an oil change. He was walking to get his oil jug when he tripped on an open lift pad, and fell to the ground landing on his right side. The employee sustained a broken right femur and was hospitalized.

An employee was descending a ladder that was on a strand when the ladder shifted, causing the employee to jump off and fall about 5.5 feet to the ground. The employee sustained a fractured right ankle.

An employee was cutting boxes using a box cutting tool and lacerated an artery in their wrist. The employee was hospitalized.

An employee was removing 2,500-foot reels of 1 cable-in-conduit (CIC) weighing ~1,022 lbs. from the back of an enclosed delivery truck. The employee was manually rolling a reel off the truck when another reel shifted and rolled forward, crushing his right hand between the two reels. The employee's right ring finger was partially amputated without loss of bone.

An employee was on an extension ladder working to replace a service line to a customer's home. The existing service line broke, causing him to fall off the ladder. He was hospitalized with a dislocated elbow and fractures in his left wrist requiring surgery.

An employee stepped on a traffic cone while walking to a truck. The employee slipped and fell, suffered a fractured and possibly dislocated ankle, and was hospitalized, requiring surgery.

An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.

An employee was cutting cabinet trim using a table saw when four fingers on his left hand were severed, resulting in hospitalization and amputation.

An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.