Performance Contractors Inc.

An employee was leaning down to install conduit. When he stood up, a 2-inch all-thread rod caught and lacerated his left eyelid.

An employee was removing a 24" OD actuator valve that weighed 10,000 pounds from a structure on the fifth floor using a lattice crane. During the lift, the valve became hung up on the permanent handrail and their left thumb was caught between the valve and the handrail. The employee sustained a partial amputation of the thumb.

A crew was using a chain fall system to rig up a hard stop (metal structural support weighing 695 lbs.). The injured employee was guiding it into position. The hard stop shifted and their right hand was caught between the suspended hard stop and the adjacent structural wall, resulting in fractured ring and little fingers.

An employee was walking back from the tool room through the scaffolding material storage area. The employee's pant leg got caught on one of the 8-foot long scaffold planks that was in a scaffold rack. The employee tripped on the scaffold plank and fell forward, landing on his left elbow. The employee sustained a compound fracture to his left arm above the elbow and was hospitalized.

A crew was using rope to move a 24" diameter blind flange from the receiving deck of elevation 4 to a lower location so it could be more easily accessed by a crane. The rope broke and the blind flange fell 15 inches to the receiving deck of elevation 3, landing on the injured employee's feet. Both feet were fractured.

An employee was using a saw to cut a piece of concrete when the piece gave way and pushed the saw into the employee's leg. The employee's leg was lacerated, requiring stitches and hospitalization.

An employee was using a utility knife to cut honeycomb paper when the knife amputated their left index fingertip.

An employee was cleaning a resident's chimney. While using a drill, the employee's glove became caught in the drill and their finger was fractured.

An employee was grinding some hardfacing on a bulldozer blade when the 9-inch grinder kicked back and lacerated his left leg above the knee. The employee was hospitalized and required surgery.

An employee was operating a rotating tool to place thread protectors on the end of pipe. Her left hand was on the rotating part of the tool when the tool engaged, resulting in a left forearm fracture and a thumb laceration.

An employee was fixing a broken purlin at a worksite when they fell from the framing to the concrete floor approximately 19 feet below. The employee sustained brain bleeding and fractures to their face, vertebrae, and wrists.

Employees were removing scaffolding that was used to repair an ion exchange tank. The line was undergoing the regen process when a piece of scaffold struck a PVC pipe that transported hydrochloric acid (HCl). The injured employee was placing material inside a scaffold rack when he was sprayed in the face with HCl and sustained chemical burns to his eyes, face, chest, right arm, and left leg.

An employee was moving a ramming machine to a staging area. While using the controls on the side of the machine, there was a sudden heavy rainfall causing the equipment to slide. The ramming machine tipped over and caught the employee against the ground. The employee sustained a fracture to the right side of their pelvis and was hospitalized.

The injured employee was training a new employee on a dough machine. She went to show where the batter comes from and her right index fingertip was cut. The employee sustained an amputation to the fingertip. The machine was not guarded at the time of the incident.

An employee was operating a roller machine on a dirt slope when the machine hit a bump and fell onto it's side. While trying to get free of the falling machine, the employee's legs were pinned by the top bar of the cage. The employee was hospitalized and his left leg was amputated. He also sustained fractures to a hand and finger.

An employee fell while moving a water canister, resulting in fractures to four fingers on her right hand.

An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.

An employee was mixing sauce using a sauce barrel mixer when his left little finger was amputated.

An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.

A temporary employee was carrying a nail gun through the warehouse when it hit his leg, activated, and fired a nail into the leg.