Struck by suspended or swinging objects n.e.c. · Amputations, avulsions, enucleations unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Performance Contractors, Inc., Venture Global LNG, PORT SULPHUR, LOUISIANA 70083
on — Amputations, avulsions, enucleations unspecified, affecting the Thumb(s).
Final narrative
An employee was removing a 24" OD actuator valve that weighed 10,000 pounds from a structure on the fifth floor using a lattice crane. During the lift, the valve became hung up on the permanent handrail and their left thumb was caught between the valve and the handrail. The employee sustained a partial amputation of the thumb.
HospitalizedAmputation Thumb(s) Valves, nozzles
More severe injuries at Performance Contractors, Inc.
A crew was using a chain fall system to rig up a hard stop (metal structural support weighing 695 lbs.). The injured employee was guiding it into position. The hard stop shifted and their right hand was caught between the suspended hard stop and the adjacent structural wall, resulting in fractured ring and little fingers.
An employee was walking back from the tool room through the scaffolding material storage area. The employee's pant leg got caught on one of the 8-foot long scaffold planks that was in a scaffold rack. The employee tripped on the scaffold plank and fell forward, landing on his left elbow. The employee sustained a compound fracture to his left arm above the elbow and was hospitalized.
A crew was using rope to move a 24" diameter blind flange from the receiving deck of elevation 4 to a lower location so it could be more easily accessed by a crane. The rope broke and the blind flange fell 15 inches to the receiving deck of elevation 3, landing on the injured employee's feet. Both feet were fractured.
On January 27, 2025, an employee was performing housekeeping. He was moving his toolbox and felt a pain in his lower abdomen. The employee was hospitalized with a hernia.
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.
An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.
An employee was placing a board on top of a bundle of steel tubing. A crane was moving a bundle of steel that struck the employee and caught them against another bundle of steel tubing. The employee sustained a crushing injury and hematoma to the right upper leg.
Employees were using a crane to lower large tree stems and branches while removing limbs and branches from the load. This caused the load to shift and strike an employee in the back, resulting in a hematoma on the lower left part of their back and a fractured ankle.
More severe injuries in this industry (NAICS 236210)
An employee was fixing a broken purlin at a worksite when they fell from the framing to the concrete floor approximately 19 feet below. The employee sustained brain bleeding and fractures to their face, vertebrae, and wrists.
Employees were removing scaffolding that was used to repair an ion exchange tank. The line was undergoing the regen process when a piece of scaffold struck a PVC pipe that transported hydrochloric acid (HCl). The injured employee was placing material inside a scaffold rack when he was sprayed in the face with HCl and sustained chemical burns to his eyes, face, chest, right arm, and left leg.
An employee was moving a ramming machine to a staging area. While using the controls on the side of the machine, there was a sudden heavy rainfall causing the equipment to slide. The ramming machine tipped over and caught the employee against the ground. The employee sustained a fracture to the right side of their pelvis and was hospitalized.
The injured employee was training a new employee on a dough machine. She went to show where the batter comes from and her right index fingertip was cut. The employee sustained an amputation to the fingertip. The machine was not guarded at the time of the incident.
An employee was operating a roller machine on a dirt slope when the machine hit a bump and fell onto it's side. While trying to get free of the falling machine, the employee's legs were pinned by the top bar of the cage. The employee was hospitalized and his left leg was amputated. He also sustained fractures to a hand and finger.
A driver was exiting his vehicle outside the plant gate when his foot slipped on the top step of the truck. He fell to the ground, landed on his left hip and elbow. The employee was hospitalized with a fractured hip/femur.
A security employee was responding to an urgent call from staff regarding a violent patient. The employee tripped and fell on the floor outside of the stairwell. The employee sustained a closed head injury, contusion of the cerebrum without loss of consciousness, and a closed fracture of the distal end of the right radius.
A temporary employee was testing an electrical starter motor. He was placing tape on the starter while the breaker was not engaged, but the starter sent an arc flash that burned his hands and stomach.
An employee was walking on a sidewalk and stubbed his toe on an elevated portion of concrete, causing him to trip and fall. The employee's right knee was dislocated.