Lakeside Roofing

A crew was pulling a 4-inch plastic gas pipe off a reel and straightening it for installation. The injured employee stepped up on the trailer to cut the last band holding the pipe in the coil on the reel. As he turned to step off the trailer, the end of the pipe rotated and sprung out of the cage surrounding the coil, striking the employee on the side of the head and knocking him off of the trailer into the roadway. The employee suffered head trauma that required hospitalization.

An employee and a co-worker were performing a pick inside a clear well. They rigged the skid pan that was full of broken concrete. When lifting, the load began to swing toward a wall. The employee tried to stop the skid pan from swinging and was struck by the pan, resulting in fractures to their left hip and wrist.

The employee had just completed refueling a lattice crane that was breaking up material and was winding the fuel hose back into the fuel truck when he was struck by the catwalk/stairs of the crane. The employee was hospitalized with a laceration to his backside, possible internal bleeding, and a broken hip.

An employee was fusing 10-inch black rubber utility pipes together using a pipe fusion machine and could not get the pipes to set correctly. The employee used a nylon strap attached to an excavator to lift one side of a pipe off a steel plate. As his hand was between two pipes, the pipes came back together, partially amputating two of his fingers.

An employee was lifting four bags of a lime blend weighing approximately 10,000 pounds using a crane. The load swung and pinned the employee against a structural I-beam, resulting in fractures to the hip and pelvis.

An employee was unloading freight from a truck when a stack of doors fell over and knocked the employee to the ground. The employee sustained a fractured femur.

An employee was performing rebar fabrication using a bending machine. The employee's glove became caught in the area where the rebar bend overlaps onto itself. The subsequent bending/cutting caused the two overlapping portions to squeeze together and amputate approximately 1/4" of his left index fingertip.

An employee was building wood detail blocking and a wood member needed to be resized. The employee took the wood member to the table saw and set the fence to the correct size. The employee pressed down on the board to control it when his left little finger contacted the running blade, resulting in an amputation.

An employee was clearing a pipe along a culvert using a motorized plumbing machine. The end of the machine got tangled and stuck in long grass and other debris. The employee went to lift the end of the machine out of the grass and clear the blockage when his hand was pulled into the machine, resulting in a partial amputation and open fracture of his left distal phalanx.

An employee was operating a router when it cut his right little finger, causing an amputation through the bone.

An employee fell while moving a water canister, resulting in fractures to four fingers on her right hand.

An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.

An employee was mixing sauce using a sauce barrel mixer when his left little finger was amputated.

An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.

A temporary employee was carrying a nail gun through the warehouse when it hit his leg, activated, and fired a nail into the leg.