Fluor Corporation

An employee was using an air-actuated pump to pump oil from a mill to a 55-gallon drum when the pump malfunctioned. The employee went to fix the pump when it activated and the piston contacted their left index fingertip, resulting in an amputation.

On June 13, 2025, an employee was applying sprayed concrete to the top of coke ovens in a tunnel that is typically around 200 degrees. Later in the day, they began to show signs of heat-related illness, resulting in hospitalization.

Employees were raising a structural steel beam (L 27' x W 24" x 104") when it fell striking the injured employee. They were lifting the beam using a beam clamp and a crane to orient it to slide in place to be bolted up. The injured employee's lower left leg was amputated. The employee also sustained serious injuries to the right leg, a bruised hand and a possible fractured cheekbone.

An employee was setting trusses at a building when he slipped and fell 5 to 8 feet, dislocating his ankle. Fall protection was worn at the time of the incident.

An employee was walking on a flatbed tractor trailer while loading equipment. He was checking to make sure chains were not trapped between the load and dunnage when he tripped over the dunnage and fell 57.5 inches off the trailer to the concrete below, fracturing his pelvis.

An employee was operating a forklift and unloading a truck. After the truck was unloaded, the employee got off the forklift and proceeded to adjust the dock plate with a hook tool. The dock plate slipped and the employee went to adjust the plate with their hand when their left middle finger got caught. Their finger was amputated above the first joint.

An employee was rotating a carbide granulator blade when his finger was caught between the blade and a stationary part of the machine. The employee's right middle finger was partially amputated and they suffered an avulsion to the right ring fingertip.

An employee was using a CNC metal lathe machine in manual mode to check that the thread blocking tool made contact with the jaws. As the employee was manually spinning the spindle, his index fingertip was crushed between the spindle's jaws and the grooving insert, resulting in a fingertip amputation.

During a material handling operation, an employee's fingertip was caught under an air conditioning unit as the unit was lowered onto a cart. The employee's fingertip was amputated.

An employee was removing a bolt from a tractor hub when their right index finger was caught between the hub and the frame. The employee's fingertip was crushed and the employee was hospitalized.

An employee was using a chain fall to install a liner in a mill. As he was setting the liner in place, his right index finger got stuck in a chain on the rigging, resulting in a fingertip amputation that required hospitalization and a surgical reattachment.

An employee was descending a fixed 15-foot ladder. The employee slipped and fell, landing on a snubber machine 8 feet below and suffering a laceration to the left thigh and a fracture to the sternum.

An employee was walking to leave the worksite, slipped on mud, and fell to the ground. The employee suffered a C5 vertebra fracture that required surgery.

An employee was lowering himself on a scissor lift after inspecting a chain hoist. An auxiliary hoist being installed on the manipulator crane fell approximately 8 feet from its installed location and struck the employee in the upper back, fracturing two vertebrae.

An employee was assembling a pump with their left little finger positioned between the impeller and the discharge spacer. The element contacted the pump case's seating position and the shaft continued to move, pinching their fingertip between the two components. The employee sustained a fingertip amputation through part of the nail. The incident occurred during training.

An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.

A casting machine jammed. An employee's hand was caught in the machine, where a belt line caught and amputated the tip of his finger.

During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.

An employee slipped on condensation on a walkway in a parking garage. She fell and suffered a closed fracture to the neck of the left femur.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.