NC Hunt Lumber

An employee was shifting a larger timber off of a smaller timber as it was going down the line when his finger was caught between the larger timber and the metal side rail of the line, resulting in a fingertip amputation.

On December 26, 2023, an employee went out to the parking lot to troubleshoot the starter of an SUV. The employee was underneath the vehicle when it started and moved and the employee's middle back area was caught under the front passenger-side tire. The employee sustained a fractured collar bone.

An employee was parking at a patient's home and exited the van to manually open the garage door. The van began rolling backward and rolled over the employee's right leg. She was hospitalized with a fractured leg.

A driver exited their truck so they could provide service for a customer when the truck began to roll away. The driver went to re-enter the truck but fell and was struck by the rear driver-side tire. The employee sustained fractures to their leg and foot.

An employee had been operating a yard tractor. He parked the vehicle and was exiting when the vehicle began to roll, causing him to fall. The employee's hand was then run over by the yard tractor, resulting in fractures to multiple fingers. The employee was hospitalized.

An employee was checking for a leak in the air brake system of a semi-truck. The employee had removed the brake chamber when the truck rolled back. One of the tires pinned the employee's right hip against the ground.

An employee was unloading freight from a truck when a stack of doors fell over and knocked the employee to the ground. The employee sustained a fractured femur.

An employee was performing rebar fabrication using a bending machine. The employee's glove became caught in the area where the rebar bend overlaps onto itself. The subsequent bending/cutting caused the two overlapping portions to squeeze together and amputate approximately 1/4" of his left index fingertip.

An employee was building wood detail blocking and a wood member needed to be resized. The employee took the wood member to the table saw and set the fence to the correct size. The employee pressed down on the board to control it when his left little finger contacted the running blade, resulting in an amputation.

An employee was clearing a pipe along a culvert using a motorized plumbing machine. The end of the machine got tangled and stuck in long grass and other debris. The employee went to lift the end of the machine out of the grass and clear the blockage when his hand was pulled into the machine, resulting in a partial amputation and open fracture of his left distal phalanx.

An employee was operating a router when it cut his right little finger, causing an amputation through the bone.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.